Whirlpool GSXE 7484 INSTRUCTION FOR USE
GSXE 7484
Before using the dishwasher, read the user instructions!
Quick Reference Guide
GB
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher
is operating. Flashes when a fault
occurs. Switches off at the end of
the programme.
Indicators
Add rinse aid
Add regeneration salt
Only add regeneration salt
immediately before starting a wash
programme.
Options
Time and failure display
Indicates in hours the time
remaining until the start of the wash
cycle. Toward the end of the
programme, during the drying cycle,
the display will indicate the time
remaining in minutes.
“F ....” Information for the AfterSales Service
3)
“Delayed start” buttons
The wash cycle can be programmed
to start after 1 - 24 hours. With each
successive touch of the button, the
delayed start indicator increases by 1
hour, and after 24 returns to
00.Then press the Start button. The
dishwasher will start at the set time.
Programme chart
Programmes Loading instructions
Automatic programme recommended for
AutoNormal
Rapid 30 min 40°C
Standard
Intensive 70°C
1) Reference programme for energy label in
compliance with EN 50242 regulations;
2) Refer to “User instructions“;
1)
50-60°C
routine washes, with dried-on food (for
example for EN 50242).
Lightly soiled crockery with no
dried-on food.
Normally soiled crockery. X X 16.0 1.05 120
50°C
Heavily soiled crockery, especially pots
and pans.
Detergent
A B
X X 13-19 1.15-1.50 90-120
X - 13.0 0.70 30
X X 22.0 2.15 125
3) Values may vary in relation to usage, e.g.:
different loads, water temperatures - above or
below 15°C - as well as water hardness and power
supply voltage, etc.
(We reserve the right to make technical modifications)
5019 496 90196
2)
Consumption
Litres kWh Minutes
3)
How to use the appliance
C
BA
Further indications are given in the single chapters and in the user instructions.
Open the door
Switch on the appliance
How to fill the
detergent dispenser
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Select a programme
Select options
Press the
Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.
Mechanical indicator lamp C.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator lamp D.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
If necessary (and if provided) the corresponding indicator
lamp lights up.
ON
button.
A:
B:
Press the START button
Turn on the water tap
close the dishwasher door
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
The selected programme
is then memorised (even
in the event of power
failure).
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the
button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme”
Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.
OFF
Loading...