Before using the dishwasher, read the user instructions!
GSX 7582 |
Quick Reference Guide |
GB |
|
|
|
|
|
|
Options
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
“Delayed start” button
The wash cycle can be programmed to start after 3-6-9 hours.
Then press the Start button. The wash programme will start at the set time.
Programme chart |
Detergent 2) |
Consumption 3) |
||||||
Programmes |
|
Loading instructions |
A |
B |
Litres |
kWh |
Minutes |
|
|
|
|
|
|
|
|
|
|
Pre-Rinse |
cold |
Crockery to be washed later. |
- |
- |
5.0 |
0.02 |
10 |
|
|
|
|
|
|
|
|
|
|
Rapid 30 min |
40°C |
Lightly soiled crockery, with no |
X |
- |
13.0 |
0.70 |
30 |
|
dried-on food. |
||||||||
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
Normal 1) |
50°C |
Normally soiled crockery. |
X |
X |
16.0 |
1.05 |
120 |
|
|
|
|
|
|
|
|
|
|
Normal |
65°C |
Normally or heavily soiled crockery. |
X |
X |
16.0 |
1.65 |
90 |
|
|
|
|
|
|
|
|
|
|
Intensive |
70°C |
Heavily soiled crockery, especially |
X |
X |
22.0 |
2.15 |
125 |
|
pots and pans. |
||||||||
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
1)Reference programme for energy label in compliance with EN 50242 regulations;
2)Refer to “User instructions“;
3)Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.
5019 496 90200
(We reserve the right to make technical modifications)
BK/I/FD/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door |
Press the ON button. |
|
Switch on the appliance |
||
|
||
|
|
|
|
Large compartment A: |
|
|
|
|
With each wash cycle. |
A B |
C |
How to fill the |
||||
detergent dispenser |
Small compartment B: |
|
|
|
|
|
For programmes with pre-wash only. |
|
|
|
|
Mechanical indicator lamp C. |
|
|
Check the |
|
|
||
rinse aid level |
Electric indicator on control panel (if provided). |
|
||
|
|
|
|
|
Check the regeneration salt level
Load the racks
Select a programme
Select options
On models with water softener system only.
Mechanical indicator lamp D.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme
is then memorised (even
Press the START button in the event of power failure).
“Change programme”
PresstheSTARTbuttonfor2sec.until theStartindicatorlamp switchesoff;
Select another programme and press the START button again.
Turn on the water tap close the dishwasher door
Wash cycle
Switch off the appliance
Shut off the water tap, unload the racks
-Only open the dishwasher if necessary (Warning: beware of hot steam).
-If the appliance is switched off during
a wash cycle, when switched on again it will resume the cycle from where it was interrupted.
At the end of the programme an acoustic signal will sound. Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
BK/II/FD/GB