GB GSX 5631 |
Quick Reference Guide |
|
|
|
|
|
|
|
|
|
|
|
|
|
On button
Off button
Further indications are given in the pages to follow and in the user instructions.
Programme selection button
Start button
Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
|
|
|
Place the detergent in the: |
|
Consumption 1) |
|
|||||||
|
|
|
small |
|
large |
|
|
||||||
|
Programme Symbol |
Programme selection and |
|
|
Normal load |
|
|||||||
|
compartment |
compartment |
|
|
|
|
|
||||||
|
and Temperature |
recommended load type |
|
|
|
|
|
||||||
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
|
|
Water |
|
Energy |
|
Time |
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|
(Litres) |
|
(kWh) |
|
(Min.) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Rapid 40° C |
Lightly soiled crockery with no dried-on food. |
- |
|
|
X |
13.0 |
|
0.85 |
|
30 |
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Bio Normal 50° C 2) |
Normally or heavily soiled crockery with dried-on food. |
|
X |
|
X |
16.0 |
|
1.24 |
|
133 |
||
|
|
|
|
|
|||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Intensive 70° C 3) |
Heavily soiled pans and saucepans. |
|
X |
|
X |
21.0 |
|
1.90 |
|
110 |
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1)Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.
2)Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for energy label.
3)Programme recommended when using detergents of type A (non enzyme-based detergents).
5019 100 90371
(We reserve the right to make technical modifications)
How to use the dishwasher |
Upper and lower rack |
1.After loading the dishwasher, turn on the water supply tap and open the dishwasher door.
2.Press the On button to switch the dishwasher on. One of the programme indicator lamps will light up.
3.Press the programme selector button until the corresponding indicator lamp switches on. If required, select options (if supplied).
4.Press the Start button to start the selected wash programme. The Start indicator lamp will light up. Once set, the programmed data cannot be altered by pressing the programme selector buttons.
Note: once the Start button has been pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.
To change the selected
programme, open the door
(caution: danger of scalding from steam!) and press the Start button for about 5 seconds, until the Start indicator lamp switches off. Select a new programme and press the Start button again.
Note: if the dishwasher is switched off during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.
Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding from steam.
5To indicate the end of a programme, an acoustic signal is activated 4 times, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min.).
6. Only open the door once the wash |
Upper rack |
cycle has terminated (caution: danger |
|
of scalding from steam) and press the |
|
OFF button to switch the dishwasher |
|
off. All the indicator lamps switch |
|
off. |
|
7.Unload the lower rack before the upper one. Close the water tap.
Crockery holders:
• Down: cups and long-stemmed glasses.
• Up: plates.
Glass holder:
Lower rack
C
Cutlery basket:
•The cutlery basket can be removed to increase (C) available space.
•Some models are provided with a grid (D) that can be fitted onto the cutlery basket.
B
D
C
Please read the user instructions carefully.