Whirlpool GSU 5531 WS INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

GSU 5531

Quick Reference Guide

Programme selector knob

On / Off button

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the
programme.

GB

Indicators

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Add rinse aid

Programme chart

Programmes Loading instructions A B

Pre-Rinse cold

Rapid 30 min 40°C

Standard

1)

Normal 65°C

Intensive 70°C

1) Reference programme for energy label in c ompliance with
EN 50242 regulations;

2) Refer to “User instructions”;

Important information for Test Laboratories:
For detailed information on the EN/Standard loading comparison test, contact the following address:
“[e-mail]”.

Crockery to be washed later. - - 5.0 0.02 10
Lightly soiled crockery, with no

dried-on food.
Normally soiled crockery. X X 16.0 1.05 140

50°C

Normally or heavily soiled crockery. X X 16.0 1.65 100
Heavily soiled crockery, especially

pots and pans.

3) Program data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, water temperatures - above or below
15°C - as well as water hardness and power supply
voltage, etc.

Detergent

X - 13.0 0.70 30

X X 17.0 1.90 135

(We reserve the right to make technical modifications)

2)

Consumption

Litres kWh Minutes

3)

5019 496 90424

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

Fill the detergent dispenser

Check the rinse aid level

Check the

regeneration salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Press the ON / OFF button.

Compartment
With each wash cycle.
Compartment
For programmes with pre-wash only.

Mechanical indicator lamp C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator lamp D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.

A:

ABC

B:

Select additional options

Press the Start button

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided).
The corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

Only after the START button has switched off: Press the ON /
All the indicator lamps switch off.

Warning: When the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme in progress”

Press the START button for 2 sec. until the
Start indicator lamp switches off.
Select another programme and press the

START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

OFF

button.