Whirlpool GSU 4996 WS INSTRUCTION FOR USE

GSU 4996

>

Before using the dishwasher, read the user instructions!

Quick Reference Guide

Wash cycle

GB

Indicators

Programmes Loading instructions A B

AutoNormal 40-55°C

AutoIntensive 60-70°C

Pre-Rinse cold

Programme selector knob

Start button

Switches “on” when the
dishwasher is operating. Flashes
when a fault occurs. Switches off
at the end of the programme.

Add rinse aid

Add regeneration salt

Only add regeneration salt
immediately before starting a
wash programme.

Programme chart

Automatic programme
recommended for routine washes,
with no dried-on or burnt food (not
for EN 50242).

Automatic programme
recommended for heavily soiled
crockery with dried-on or burnt food,
for example pans and saucepans.

Crockery to be washed later. - - 4.0 0.03 14

Pre-Rinse Washing Drying

Options

“Delayed start” button

The wash cycle can be programmed to
start after 3-6-9 hours. Then press the Start
button. The wash programme will start at
the set time.

“Half load” button

This function can be used with any
programme. The indicator lamp switches
on. The wash cycle is activated for the

or

upper

lower rack
When washing without the top rack, press
the “Half Load” button (LED alight).

Detergent

X X 10-13 0.8-1.05 60-120

X X 13-20 1.1-2.0 100-150

only

2)

Litres kWh Minutes

Programme

end

.

Consumption

3)

Glass 40°C

Rapid 30 min 40°C

1)

Eco

1) Reference programme for energy label in
compliance with EN 50242 regulations;

2) Refer to “User instructions“;

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“[e-mail]”.

Light soiling, for example glasses and
cups.

Lightly soiled crockery with no
dried-on food.

Normally soiled crockery. X X 13.0 1.05 145

50°C

3) Program data obtained in conformity with
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.

(We reserve the right to make technical modifications)

X - 10.0 0.80 55

X - 10.0 0.65 30

5019 496 90320

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Automatic start by turning the programme selector knob (in
case of retractable knob, first press the knob to access it).

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D.
Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

Select the desired programme.
The corresponding indicator lamp comes on.

A:

CBA

B:

Select additional

options

Press the START button

Wash cycle

Switch off the appliance

Shut off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator
lamp lights up.

The selected programme
is then memorised (even
in the event of power
failure).

Only after the START button has switched off: access the knob
(in case of retractable knob, press and then release the knob).

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and press

the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.