Whirlpool GSIP 6798 SW, GSIP 6798 WS INSTRUCTION FOR USE

GSIP 6798

Indicators

Before using the dishwasher, read the user instructions!

Quick Reference Guide

Wash cycle

Programme selector knob

Pre-Rinse Washing Drying

Options

On / Off button

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Add regeneration salt

Only add regeneration salt immediately before starting a wash programme.

Add rinse aid

Time and failure display

Indicates in hours the time remaining until the start of the wash cycle. Switches off when the programme starts and indicates the time remaining in hours and minutes.

“F....” Information for the After-Sales

Service

“Delayed start” buttons

The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to

00. Then press the Start button. The dishwasher will start at the set time.

“Half load” button

This function can be used with any programme. The indicator lamp switches on. The wash cycle is activated for the upper When washing without the top rack, press the “Half Load” button (LED alight).

Programme

lower rack

end

only

Programme chart

Detergent

Programmes Loading instructions A B

Pre-Rinse cold

Glass 40°C

Rapid 30 min 40°C

Eco 50°C

Standard

Hygiene +

4) 5)

Intensive 70°C

1) Reference programme for energy label in compliance with EN 50242 regulations;

2) Refer to “User instructions“;

3) Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C as well as water hardness and power supply voltage, etc.

Important information for Test Laboratories: For detailed information on the EN comparison test and other tests, contact the following addre ss: “nk_cu stomer@whirl pool.c om”.

Crockery to be washed later. - - 4.0 0.03 14 Light soiling, for example glasses

and cups. Lightly soiled crockery with no

dried-on food. Normally soiled crockery. X - 10.0 1.30 85

Normally soiled crockery. X X 13.0 1.05 145

50°C

Normally or heavily soiled crockery, with additional antibacterial action.

Heavily soiled crockery, especially pots and pans.

4) The bacteria removal efficiency has been tested by the Institut Pasteur de Lille (France), based on the NF EN 13697 standard of November 2001.

5) Programme interruption (e.g. the door being opened) may compromise the result of the antibacterial rinse.

X - 10.0 0.80 55

X - 10.0 0.65 30

X X 13.0 1.50 115

X X 14.0 1.70 150

(We reserve the right to make technical modifications)

Consumption

Litres kWh Minutes

5019 496 90379

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Press the ON/ OFF button.

Large compartment With each wash cycle. Small compartment For programmes with pre-wash only.

Mechanical indicator C. Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D. Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up. Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up.

CBA

Select additional

options

Press the START button

Wash cycle

Switch off the appliance

Shut off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is then memorised (even in the event of power failure).

Only after the START button has switched off: Press the

OFF

ON /

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

button. All the indicator lamps switch off.

“Change programme”

Press the STAR T button for 2 sec. until the Start indicator lamp switches of f;

Select another program m e and press the START button again.

- Only open the dishwasher if necessary (Warning: beware of hot steam).

- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

+ 2 hidden pages