Whirlpool GSIK 6584 BR BK, GSIK 6584 IN BK, GSIK 6584 WH BK INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

GSIK 6584

Programme selector knob

On / Off button

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.

Quick Reference Guide

Options

3)

Time and failure display

Indicates in hours the time remaining until the
start of the wash cycle. Switches off when the
programme starts and indicates the time
remaining in hours and minutes.

“F....” Identification of faults for service technician

“Delayed start” button

The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the
button, the delayed start indicator increases by 1
hour , and after 24 returns to 00. Then press the Start
button. The dishwasher will start at the set time.

“Half Load” button

Possibility of only half loading the top and bottom
racks. Select the required programme then press
the “Half Load” button. The light comes on and
goes off at the end of the programme.
The “Half Load” function can be used with
programmes marked with an *.

GB

Antibacterial rinse

Indicators

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Add rinse aid

Programme chart

This function adds an antibacterial rinse at the end
of the wash cycle, thereby guaranteeing a perfectly
clean and sanitized load. The lamp will light up
when the function is activated. If the temperature is
not maintained during the antibacterial cycle (e.g. if
the door is opened and remains open for a long
time), the lamp will start blinking to indicate that
sanitation is not guaranteed.

Detergent2)Consumption

Programmes Loading instructions A B

Pre-Rinse cold
Quickwash 40°C

1) 5) 6) (*)

Bio

5) (*)

Daily
Intensive

1) Reference programme for energy label in c ompliance with
EN 50242 regulations;

2) Refer to “User instructions”;

3) The data relevant to programmes are values obtained in the
laboratory in conformity with Standard EN 50242. In practical
use there may be time variations or leaps depending on
different loads, function options, water temperatures or
hardness and different power supply voltages.

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“[e-mail]”.

5)

Crockery to be washed later. - - 5.0 0.02 10
Lightly soiled crockery with no

dried-on food.
Normally soiled crockery. X X 16.0 1.05 195

50°C

Normally or heavily soiled

60°C

crockery.
Recommended programme for

heavily soiled crockery, especially

70°C

suitable for pans and saucepans.

4) The bacteria removal efficiency has been tested by the
Institut Pasteur de Lille (France), based on the NF
EN 13697 standard of November 2001.

5) These programmes can be used with the Antibacterial
rinse option.

6) Energy saving programme with prolonged drying cycle.

(We reserve the right to make technical modifications)

X - 13.0 0.70 30

X X 16.0 1.35 120

X X 17.0 1.65 145

4) 5)

3)

Litres kWh Minutes

5019 496 90510

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

Fill the detergent dispenser

Check the rinse aid level

Check the

regeneration salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Press the ON / OFF button.

Compartment
With each wash cycle.
Compartment
For programmes with pre-wash only.
If using combined action dishwasher

tabs, follow the user instructions!

Mechanical indicator lamp C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator lamp D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.

A:

B:

ABC

Select additional options

Press the Start button

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided).
The corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

Only after the START button has switched off: Press the ON /
All the indicator lamps switch off.

Warning: When the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme in progress”

Press the START button for 2 sec. until the
Start indicator lamp switches off.
Select another programme and press the

START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

OFF

button.