Whirlpool GSIK 6522 IN INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

GSIK 6522	Quick Reference Guide										GB

Wash cycle

Programme selector knob

Pre-Rinse

Washing

Drying Programme

end

Options

On / Off button

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Indicators

Add regeneration salt

Only add regeneration salt immediately before starting a wash programme.

Add rinse aid

“Delayed start” button

The wash cycle can be programmed to start after 3-6-9 hours. Then press the Start button. The wash programme will start at the set time.

“Half Load” button

The half load cycle can be used for the upper and lower rack. Select the required programme then press the “Half Load” button. The light comes on and goes off at the end of the programme.

The “Half Load” function can be used with programmes marked with an *.

		Programme chart			Detergent 2)		Consumption 3)
		Programmes		Loading instructions	A	B	Litres	kWh	Minutes
		Pre-Rinse	cold	Crockery to be washed	-	-	5.0	0.02	10
				later.
		Rapid 30 min	40°C	Lightly soiled crockery,	X	-	13.0	0.70	30
				with no dried-on food.
		Bio 1) *)	50°C	Normally soiled crockery.	X	X	16.0	1.05	195
		Daily *)	60°C	Normally or heavily soiled	X	X	16.0	1.35	120
				crockery.
		Intensive	70°C	Heavily soiled crockery,	X	X	17.0	1.65	145
				especially pots and pans.

1)	Reference programme for energy label in	3) Programme data obtained in conformity with
	compliance with EN 50242 regulations;	European standard EN 50242. Values may vary in
2)	Refer to “User instructions“;	relation to usage, e.g.: different loads, water
		temperatures - above or below 15°C - as well as
		water hardness and power supply voltage, etc.

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address: “[e-mail]”.

5019 496 98053

(We reserve the right to make technical modifications)

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the detergent dispenser

Check the rinse aid level

Check the regeneration salt level

Load the racks

Close the door, turn on the water tap

Select a programme

Select additional options

Press the ON / OFF button.
Large compartment A:
With each wash cycle.	A	B C
Small compartment B:
For programmes with pre-wash only.
If using combined action dishwasher
tabs, follow the user instructions!

Mechanical indicator C.

Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D.

Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.

Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up.

If necessary (and if provided) the corresponding indicator lamp lights up.

Press the START button

Wash cycle

Switch off the appliance

Shut off the water tap, unload the racks

The selected programme is then memorised (even in the event of power failure).

“Change programme”

Press the START button for 2 sec. until the Start indicator lamp switches off; Select another programme and press the START button again.

-Only open the dishwasher if necessary (Warning: beware of hot steam).

-If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

Only after the START button has switched off: Press the ON / OFF button. All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.