Whirlpool GSIK 6453/1 IN INSTRUCTION FOR USE

GSIK 6453

Before using the dishwasher, read the user instructions!

Quick Reference Guide

Programme cycle

GB

Programme selector knob

On / Off button

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.
Switches off at the end of the programme.

Indicators

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Add rinse aid

Programmes Loading instructions A B

Programme chart

Pre-Rinse Washing Drying End

Options

“Delayed start” button

The wash cycle can be programmed to start
after 3-6-9 hours. Then press the Start button.
The wash programme will start at the set time.

Detergent

2)

Consumption

Litres kWh Minutes

3)

Pre-Rinse cold

Rapid 30 min 40°C

Standard

1)

Intensive 70°C

1) Reference programme for energy label EN 50242

2) Refer to “User instructions”;

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“[e-mail]”.

Crockery to be washed later. - - 5.0 0.02 10
Lightly soiled crockery with no

dried-on food.
Normally soiled crockery. X X 16.0 1.05 160

50°C

Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.

3) Program data obtained in conformity with
European standard EN 50242. Values may vary
in relation to usage, e.g.: different loads,
water temperatures - above or below 15°C - as
well as water hardness and power supply
voltage, etc.

(We reserve the right to make technical modifications)

X - 13.0 0.70 30

X X 17.0 1.90 135

5019 496 90414

How to use the appliance

CBA

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Press the ON/ OFF button.

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D.
Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.

A:

B:

Select additional

options

Press the START button

Wash cycle

Switch off the appliance

Shut off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator
lamp lights up.

The selected programme
is then memorised (even
in the event of power
failure).

Only after the START button has switched off: Press the
ON /

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

button. All the indicator lamps switch off.

OFF

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.