Whirlpool DWH B00W, GSI 4633 BW-BR, GSI 4633 BW-WS, GSI 4633 BW-IN INSTRUCTION FOR USE
GB
GSI 4633
PROGRAMME CHART
Start button indicator lamp
Switches “on” when the dishwasher is operating.
Flashes when a fault occurs.
Switches “off” at the end of the programme
Programme
Symbol and
Temperature
Pre-rinse
Bio-Normal 50° C
Normal 65° C
*) Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.
1) Programme recommendedwhen using detergents of type A (non enzyme-based detergents).
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Check the programme on the energy data plate.
Crockery to be washed later.
2)
Normally or heavily soiled crockery with dried-on food.
1)
Normally or heavily soiled crockery.
Crockery and cutlery
Load
Detergent
Pre-rinse
(small
compartment)
--8.00.0212---
+ + 19.01.4585---
+ + 19.01.6385---
Pre-rinse
(large
compartment)
(We reserve the right to make technical modifications)
Consumption *
Normal load
Water
(Liter)
Energy
(kWh)
Time
(Min.)
5019 100 90503
Quick Reference Guide
GB
Daily check list
1. Arrange crockery so that items do
not touch each other.
2. Load cups at an inclination to
facilitate water circulation.
3. In general, place cutlery in the basket
with the handles positioned
downwards, but ensure that any
sharp knives and forks that might
cause injury are placed in the basket
with the handles positioned upwards.
4. Make sure the water jet can reach
all loaded items and that the spray
arms turn freely.
5. Turn on the water supply tap before
starting the dishwasher.
Important:
• Switch off the dishwasher: once
the “Start” indicator lamp has
switched off.
If you switch off the dishwasher
during a wash cycle, when
switched on again the
dishwasher resumes the cycle
from where it was interrupted.
• If a fault occurs or you wish to
change the current programme,
press the “START” button for
about 5 seconds until the Start
indicator lamp switches off!
Refer to the “Troubleshooting
Guide” in these user instructions
to remedy any problems.
• If a regeneration salt is to be
added, IMMEDIATELY
washing programme, in
order to eliminate any
residual salt.
• If a fault occurs or you wish to
change the current programme,
press the “START” button.
Sometimes even when the
regeneration salt container is full,
the corresponding indicator
lamp may illuminate during the
first wash cycle.
start a
Crockery Holders:
• Down: cups and long-stemmed
glasses.
• Up: plates.
Upper rack
Lower rack
Cutlery Basket:
The cutlery basket can be removed to
increase available space.
Also refer to the “Dishwasher Loading Instructions” which contain detailed information and useful tips.
Loading...