Whirlpool GSF STUTTGART PRESTIGE WS INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

GSF Stuttgart

Quick Reference Guide

Wash cycle

Programme selector knob

On/Off button

Start button

Switches “on” when the dishwasher

is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Indicators

Add regeneration salt

Only add regeneration salt

immediately before starting a wash programme.

Add rinse aid

Programmes Loading instructions A B

AutoNormal

AutoIntensive

Programme chart

Automatic programme recommended for

40-55°C

60-70°C

routine washes, with no dried-on or burnt food (not for EN 50242).

Automatic programme recommended for heavily soiled crockery with dried-on or burnt food, for example pans and saucepans.

Pre-Rinse Washing Drying

Options

Time and failure display

Indicates in hours the time remaining until the start of the wash cycle. Switches off when the programme has started and indicates the time remaining in hours and minutes.

“F...” Information for the After-Sales Service

“Delayed start” button

The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00.Then press the Start button. The dishwasher will start at the set time.

Detergent

X X 10-13 0.8-1.05 50-110

X X 13-20 1.1-2.0 90-140

Programme

end

Consumption

Litres kWh Minutes

Crockery to be washed later. - - 4.0 0.03 14

Pre-Rinse

Glass

Rapid 30 min

Standard

1) Reference programme for energy label in compliance with EN 50242 regulations;

2) Refer to “User instructions“;

cold

Light soiling, for example glasses and cu ps. X - 10.0 0.80 55

40°C

Lightly soiled crockery with no

40°C

dried-on food.

Normally or heavily soiled crockery. X X 13.0 1.05 120

50°C

X - 10.0 0.65 30

3) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.

(We reserve the right to make technical modifications)

5019 496 90231

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Press the ON/ OFF button.

Large compartment With each wash cycle. Small compartment For programmes with pre-wash only.

Mechanical indicator lamp C. Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator lamp D. Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up. Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up.

Select additional

options

Press the START button

Wash cycle

Switch off the appliance

Shut off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is then memorised (even in the event of power failure).

Only after the START button has switched off: Press the

OFF

ON /

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

button. All the indicator lamps switch off.

“Change programme”

Press the START button for 2 sec. until the Start indicator lamp switches off;

Select another programme and press the START button again.

- Only open the dishwasher if necessary (Warning: beware of hot steam).

- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

+ 2 hidden pages