Whirlpool GSFS 60002 A, DLC 6008 INSTRUCTION FOR USE

GBD

5019 609 02013 Printed in Italy 07/12 - Bauknecht

1. Press the On/Off button.

2. Select the suitable program for your dishes by means of the Program Selection Knob.

3. Start the program by pressing the Start/Pause button.

Start/Pause lamp goes out as soon as the program starts and Wash lamp lights up.

Lamp on the Start/Pause button lights up when the On/Off button is pressed.

OPERATING THE MACHINE

q e w

1. Press the Start/Pause button.

2. Select the desired program by using the Program

Selection Knob after current program stops.

3. Start the new program by pressing the Start/Pause button again. The new program resumes from the point that the previous program has stopped.

qe w

You can follow the program flow by means of the program follow-up lamps on the control panel.

As long as washing continues the lights of washing, rinsing and drying are on respectively. Machine remains silent for about 40-50 minutes when the drying lamp is on.

When the program ends, end lamp lights up. Do not open the door before the program ends.

PROGRAM FOLLOW-UP

If you would like to change the program when a washing program is in progress.

CHANGING THE PROGRAM

1. Press the Start/Pause button.

2. Turn the Program Selection Knob to Cancel position

3. Press the Start/Pause button again. Machine discharges

the water in it approximately for 30 seconds after pressing the button.

4. Program will be cancelled when the End lamp lights up.

qrew

If you would like to cancel a washing program while it is running.

CANCELING A PROGRAM