Whirlpool GSFH 2988 WS INSTRUCTION FOR USE
GSFH 2988
Before using the dishwasher, read the user instructions!
Quick Reference Guide
GB
On / Off button
Programme selector
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Add regeneration salt
Only add regeneration sa lt immediately
before starting a wash programme.
Add rinse aid
No water
Check that the appliance fills with water.
Programmes Loading instructions A B
Auto Normal 40-55°C
Auto Intensive 60-70°C
Pre-Rinse cold
Programme chart
Automatic programme recommended for
routine washes, with no dried-on or burnt
food (not for EN 50242).
Automatic programme recommended for
heavily soiled crockery with dried-on or
burnt food, for example pans and saucepans.
Crockery to be washed later.
Wash cycle
Pre-Rinse Washing Drying
Options
Time and failure display
Indicates in hours the time remaining until the start o f
the wash cycle. Switches off at programme start and
indicates the remaining time in hours and minutes.
“F....” Information for the After-Sales Service
“Delayed start” buttons
The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the
button, the delayed start indicator increases by 1
hour, and after 24 returns to 00. Then press the Start
button. The dishwasher will start at the set time.
“Half Load” button
This function can be used with any programme.
The indicator lamp switches on. The wash cycle is
activated for the upper
When washing without the top rack, press the
“Half Load” button (LED alight).
Detergent
X X 10-13 0.8-1.05 60-120
X X 13-20 1.1-2.0 100-150
- - 4.0 0.03 14
or
2)
Litres kWh Minutes
Programme
3)
lower rack
only
Consumption
end
.
3)
Glass 40°C
Rapid 30 min 40°C
1)
Eco
Hygiene +
1) Reference programme for energy label in compliance with
EN 50242 regulations;
2) Refer to “User instructions“;
3) Values may vary in rel ation to usage , e.g.: dif fer ent lo ads,
water temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
4) 5)
Light soiling, for example glasses and cups.
Lightly soiled crockery, with no dried-on
food.
Normally soiled crockery.
50°C
Normally or heavily soiled crockery, with
additional antibacterial action.
4) The bacteria removal efficiency has been tested by the
Institut Pasteur de Lille (France), based on the NF EN
13697 standard of November 2001.
5) Programme interruption (e.g. the door being opened)
may compromise the result of the antibacterial rinse.
(We reserve the right to make technical modifications)
X - 10.0 0.80 55
X - 10.0 0.65 30
X X 13.0 1.05 120
X X 13.0 1.50 115
5019 496 90362
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Switch on the appliance
How to fill the
detergent dispenser
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Close the door,
turn on the water tap
Select a programme
Press the ON/ OFF button.
Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator D.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.
A:
CBA
B:
Select additional
options
Press the START button
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
If necessary (and if provided) the corresponding indicator
lamp lights up.
The selected programme
is then memorised (even
in the event of power
failure).
Only after the START button has switched off: Press the
OFF
ON /
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
button. All the indicator lamps switch off.
“Change programme”
Press the STAR T button for 2 sec. until
the Start indicator lamp switches of f;
Select another program m e and
press the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.
Loading...