Whirlpool GSFH 1581 WS INSTRUCTION FOR USE

GSFH 1581

Before using the dishwasher, read the user instructions!

Quick Reference Guide

Options

GB

Programme selector knob

On / Off button

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.

Indicators

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Add rinse aid

Programme chart

Programmes Loading instructions A B

Pre-Rinse cold

Crockery to be washed later. - - 4.0 0.03 14

“Half load” button

This function can be used with any
programme. The indicator lamp switches on.
The wash cycle is activated for the upper
lower rack
When washing without the top rack, press
the “Half Load” button (LED alight).

Detergent

only

.

2)

Consumption

Litres kWh Minutes

or

3)

Rapid 30 min 40°C

Normal

Hygiene +

Intensive 70°C

1) Reference programme for energy label in
compliance with EN 50242 regulations;

2) Refer to “User instructions“;

3) Program data obtained in conformity with
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“[e-mail]”.

1)

4) 5)

Lightly soiled crockery with no drie d-o n food. X - 10.0 0.65 30

Normally soiled crockery. X X 13.0 1.05 135

50°C

Normally or heavily soiled crockery, with
additional antibacterial action.

Heavily soiled crockery, especially pots and
pans.

4) The bacteria removal efficiency has been tested
by the Institut Pasteur de Lille (France), based on
the NF EN 13697 standard of November 2001.

5) Programme interruption (e.g. the door being
opened) may compromise the result of the
antibacterial rinse.

(We reserve the right to make technical modifications)

X X 13.0 1.50 115

X X 14.0 1.70 150

5019 496 90353

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Press the ON/ OFF button.

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D.
Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.

A:

CBA

B:

Select additional

options

Press the START button

Wash cycle

Switch off the appliance

Shut off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator
lamp lights up.

The selected programme
is then memorised (even
in the event of power
failure).

Only after the START button has switched off: Press the

OFF

ON /

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

button. All the indicator lamps switch off.

“Change programme”

Press the STAR T button for 2 sec. until
the Start indicator lamp switches of f;

Select another program m e and
press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.