Whirlpool GSF BOLERO INSTRUCTION FOR USE
GB
DYNAMIC SENSE: Energy savings and optimum wash results
The two sensor-controlled “DYNAMIC SENSE” wash options are
recommended for routine washes. They use double-sensor
technology. Separate sensors gauge turbi dity and partic les in orde r to
determine the degree of soiling of the wash w ater. In accordance with
values measured, a microprocessor establishes optimum water,
energy and time consumption. Optimum wash results are thus
achieved using only those resources strictly required.
GSF BOLERO
Further indications are given in the pages to follow and in the user instructions.
Water supply indicator
Check the appliance fills with water.
Lower spray arm block indicator.
Release the spray arm.
“Water stop” device indicator
“Water stop” device not working.
Switch off the dishwasher and shut off the water tap.
Rinse aid level indicator
Add rinse aid.
Salt level indicator
Add regeneration salt; only add regeneration sa lt immediately before
starting a wash programme.
Programme Symbol
and Temperature
Programme selection and
recommended load type
Quick Reference Guide
Programme progress indicator
Pre-rinse /
Pre-wash
Washing
Delayed start button
Set the desired delay: 3, 6 or 9 hours.
Press the Start button.
The dishwasher will start at the set time.
small compartment large compartment
Option
Place the detergent in the:
Drying
Programme
end
Start button
Indicator lamp lit while the dishwasher
is operating.
Flashes when a fault occurs.
Switches off at the end of the
programme.
On / Off Button
1)
Time
(Min.)
Water
(Litres)
Consumption
Normal load
Energy
(kWh)
Eco Normal 40 - 55° C
Intensive 60 - 70° C
Pre-wash
Rapid 40° C
Glasses 40° C
Standard 50° C
1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C as well as water hardness and power supply voltage.
2) Reference programme for Test Institute and ener gy-label.
Recommended programme
for crockery with little or no dried-on food.
Recommended programme
crockery
pans and saucepans.
Crockery to be washed later.
Lightly soiled crockery with no dried-on food.
Light soiling, especially glasses and cups.
Normally or heavily soiled crockery with dried-on
2)
food.
, with dried-on food. Especially suitable for
for routine washes
for heavily soiled
,
X X
X X
- - 5.0 0.02 9
- X 13.0 0.85 30
- X 12.0 0.82 60
X X 16.0 1.05 120
5019 100 90233
(We reserve the right to make technical modifications)
B
A
C
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. Press the On/Off button to switch the
dishwasher on.
indicator lamps will switch on.
3. Select the desired programme by
pressing the corresponding button.
corresponding indicator lamp lights
If required, select options (if supplied).
up.
4. Press the Start button to start the
selected programme.
indicator lamp will light up.
the programmed data cannot be
altered by pressing the programme
selector buttons.
Once the Start button has been
Note:
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start
button for about 5 seconds
the Start indicator lamp
switches off.
programme using the
programme selector knob and
press the Start button.
If the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
switches on
One of the programme
The Start
Once set,
Select a new
(for about 30 min.)
, until
.
6. Once the Start indicator lamp has
switched off press the On/Off button to
switch the dishwasher off.
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
The
Upper rack
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
• To lower: pull out the
handles and gently lower the rack.
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both
sides.
two
All the
side
two
side handles
Upper and lower rack
Crockery holders:
• Down: cups and long-stemmed glasses.
•
Up: plates.
“Vario Organizer” multi-purpose
support:
• To be used, for example, for longhandled utensils
with the blade facing downwards),
cups and glasses.
• May be used in three different
positions (see also “Dishwasher
loading instructions” on Page 4).
1. Upon the left-hand side of the rack.
2. Upside-down, towards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
(arrange knives
Lower rack
B
A
Plate holders:
• May be lowered to increase
available space (A).
• May be removed to increase available
space (B). To remove: pull the handle
up.
Cutlery basket:
The cutlery basket can be removed to
increase (C) available space.
C
Please read the user instructions carefully.
Loading...