Whirlpool GSF 7199 TW-WS, GSF 7197 TW-WS INSTRUCTION FOR USE

DYNAMIC SENSE: Energy savings and optimum wash results

The two sensor-controlled “DYNAMIC SENSE” wash options are recommended for routine washes. They use double-sensor technology. Separate sensors gauge turbid ity an d pa rticle s in o rder to determine the degree of soiling of the wash w ater. In accordance with values measured, a microprocessor establishes optimum water, energy and time consumption. Optimum wash result s are thus achieved using only those resources strictly required.

GSF 7197

Further indications are given in the pages to follow and in the user instructions.

Quick Reference Guide

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add regeneration salt immediately before starting a wash programme.

Programme Symbol

and Temperature

Eco Normal 40 - 55° C

Intensive 60 - 70° C

Pre-wash

Rapid 40° C Glasses 40° C

Bio 50° C

Recommended programme little or no dried-on food.

Recommended programme dried-on food. Especially suitable for pans and saucepans.

Crockery to be washed later.

Lightly soiled crockery with no dried-on food.

Light soiling, especially glasses and cups.

Normally or heavily soiled crockery with dried-on food.

Programme selection and

recommended load type

for routine washes

for heavily soiled crockery

, for crockery with

, with

Start button

Indicator lamp lit while the dishwasher is operating.

Flashes when a fault occurs. Switches off at the end of the programme.

On / Off Button

Place the detergent in the:

small large

compartment compartment

Water

(Litres)

X X

- - 5.0 0.02 9

- X 13.0 0.85 30

- X 12.0 0.82 60

X X 16.0 1.05 120

Consumption

Normal load

Energy

(kWh)

Time

(Min.)

1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C - as well as water hardness and po wer supply voltage etc.

2) Reference programme for Test Institute and ene r gy-label.

5019 100 90330

(We reserve the right to make technical modifications)

How to use the dishwasher

1. After loading the dishwasher, cl ose the door properly and open the water supply tap.

2. Press the On/Off button to switch the dishwasher on.

indicator lamps will switch on.

3. Select the desired programme by pressing the corresponding button.

The corresponding indicator lamp lights up.

supplied).

4. Press the Start button to start the selected programme.

indicator lamp will light up.

the programmed data cannot be altered by pressing the programme selector buttons.

once the Start button has been

Note:

pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.

To change the selected programme, press the Start button for about 5 seconds

indicator lamp switches off.

Select a new programme using the programme selector knob and press the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding from steam.

5. To indicate the end of the programme, the Start indicator lamp switches off and

the End indicator lamp (if fitted)

lights up

One of the programme

If required, select options (if

The Start

Once set,

, until the Start

(for about 30 min.)

6. Once the Start indicator lamp has switched off press the On/Off bu tton to switch the dishwasher off.

indicator lamps switch off.

7. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

All the

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded.

• To lower: pull out the handles and gently lower the rack.

• To raise: pull up the until the rack clicks into place.

• The rack must be level on both sides.

two

side handles

two

side

Upper and lower rack

Crockery holders:

• Down: cups and long-stemmed glasses.

•

Up: plates.

Glass holder:

Lower rack

Plate holders:

• May be lowered to increase available space (A).

Cutlery basket:

• The cutlery basket can be removed to increase (C) available space.

• Some models are provided with a grid (D) that can be fitted onto the cutlery basket.

Please read the user instructions carefully.

+ 2 hidden pages