Whirlpool GSF 5476 TW-WS, GSF 5476 TW-SW INSTRUCTION FOR USE
GB
GSF 5476
Water supply indicator
Check the appliance fills with water.
Lower
spray arm block indicator.
Release the spray arm.
"Water stop" device indicator
"Water stop" device not working.
Switch off the dishwasher and shut off the
water tap.
Rinse aid level indicator
Add rinse aid.
Salt level indicator
Add regeneration salt; only add
regeneration salt immediately before
starting a wash programme.
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Programme progress indicator
Pre-rinse /
Pre-wash
Washing
Eco-Dry
The indicator lamp switches on during dry
cycles without fans.
Half Load button
This function can be used with any
programme. The indicator lamp switches on:
The wash cycle is activated for the upper or
lower rack
Options
only
.
Drying
Programme end
Delayed start buttons
The wash cycle can be programmed to start after 1-24 hours. Then
press the Start button. The dishwasher will start at the set time.
Time and failure display
Indicates in hours the time remaining until the start of the wash cycle.
Switches off when the programme has started. Toward the end of the
programme, during the drying cycle, the display will indicate the time
remaining in minutes.
Identification of faults for service technician.
“F1-F9”
Start button
Indicator lamp lit while the dishwa sher is op era tin g. Fla she s wh en a f au lt
occurs.
Switches off at the end of the programme.
On / Off Button
Place the detergent in the:
Programme Symbol
and Temperature
Pre-wash
Glasses 40° C
Rapid 40° C
Bio-Eco 50° C
Bio-Normal 50° C
Normal 65° C
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water temperatures -above or below 15° C-, water hardness and
power supply voltage, etc.
2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for energy label.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
3)
Crockery to be washed later.
Light soiling, especially glasses and cups.
Lightly soiled crockery with no dried-on food.
Normally soiled crockery, with dried-on food.
Normally or heavily soiled crockery with dried-on food.
2)
Normally or heavily soiled crockery with dried-on food.
Heavily soiled pans and saucepans.
Programme selection and
recommended load type
small compartment large compartment
- - 5.0 (4.2) 0.02 (0.02) 9(9)
- X 12.0 (10.0) 0.82 (0.78) 60 (59)
- X 13.0 (13.0) 0.85 (0.75) 30 (30)
- X 12.0 (10.0) 1.25 (1.19) 73 (71)
X X 16.0 (14.5) 1.24 (1.10) 91 (88)
X X 16.0 (13.4) 1.55 (1.37) 86 (80)
X X 21.0 (18.0) 1.68 (1.57) 93 (90)
Consumption 1)
Normal load / (Half load)
Water
(Litres)
Energy
(kWh)
Time
(Min.)
5019 100 90268
(We reserve the right to make technical modifications)
B
A
C
C
How to use the dishwasher
1. After loading the dishwasher, cl ose the
door properly and open the water
supply tap.
2. Press the On/Off button to switch the
dishwasher on.
indicator lamps will switch on.
3. Select the desired programme by
pressing the corresponding button.
corresponding indicator lamp lights
If required, select options (if supplied).
up.
4. Press the Start button to start the
selected wash programme.
indicator lamp will light up.
the programmed data cannot be
altered by pressing the programme
selector buttons.
once the Start button has been
Note:
pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory
even during interruption of the power
supply.
To change the selected
programme, press the Start button
for about 5 seconds,
indicator lamp switches off.
Select a new programme using the
programme selector knob and
press the Start button.
If the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
lights up
One of the programme
until the Start
(for about 30 min.)
The Start
Once set,
.
6. Once the Start indicator lamp has
switched off press the On/Off bu tton to
switch the dishwasher off.
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
The
Upper rack
Half Load:
If the upper rack
cultery basket from the lower rack and place it
in the upper one.
is to be filled, remove the
only
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
• To lower: pull out the
handles and gently lower the rack.
• To raise: pull up the
until the rack clicks into place.
two
Please read the user instructions carefully.
All the
side
two
side handles
• The rack must be level on both
sides.
Crockery holders:
• Down:
cups and long-stemmed glasses.
•
Up: plates.
“Vario Organizer” multi-purpose
support:
• To be used, for example, for longhandled utensils
with the blade facing downwards),
cups and glasses.
• May be used in three different
positions (see also “Dishwasher
loading instructions” on Page 4).
1. Upon the left-hand side of the rack.
2. Upside-down, towards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
Upper and lower rack
Half Load:
Loading the lower rack
greater washing power, especially for
plates and saucepans.
(arrange knives
Plate holders:
Cutlery basket:
The cutlery basket can be removed to
increase (C) available space.
Lower rack
gives
only
• May be lowered to increase
available space (A).
• May be removed to increase
available space (B). To remove:
pull the handle up.
B
A
Loading...