Whirlpool GSF 5465 W-WS INSTRUCTION FOR USE
GB
GSF 5465
Rinse aid level indicator
Add rinse aid.
Salt level indicator
Add regeneration salt; only add
regeneration salt immediately before
starting a wash programme.
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Programme progress indicator
Pre-rinse / Pre-wash
Washing
Option
Half Load button
This function can be used with any programme. The indicator
lamp switches on: the wash cycle is activated for the upper or
lower rack only.
Drying
Programme end
Start button
Indicator lamp lit while the dishwasher is
operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
On / Off Button
Place the detergent in the:
Programme Symbol
and Temperature
Pre-wash
Rapid 40° C
Bio-Eco 50° C
Bio-Normal 50° C
Normal 65° C
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water temperatures -above or below 15° C-, water hardness
and power supply voltage, etc.
2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for
energy label.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
2)
3)
Programme selection and
recommended load type
Crockery to be washed later.
Lightly soiled crockery with no dried-on food.
Normally soiled crockery, with dried-on food.
Normally or heavily soiled crockery with dried-on
food.
Normally or heavily soiled crockery with dried-on
food.
Heavily soiled pans and saucepans.
small compartment large compartment
- - 5.0 (4.2) 0.02 (0.02) 9(9)
- X 13.0 (13.0) 0.85 (0.75) 30 (30)
- X 12.0 (10.0) 1.25 (1.19) 73 (71)
X X 16.0 (14.5) 1.24 (1.10) 91 (88)
X X 16.0 (13.4) 1.60 (1.37) 86 (80)
X X 21.0 (18.0) 1.68 (1.57) 93 (90)
Consumption 1)
Normal load / (Half load)
Water
(Litres)
Energy
(kWh)
Time
(Min.)
5019 100 90254
(We reserve the right to make technical modifications)
C
C
How to use the dishwasher
1. After loading the dishwasher, cl ose the
door properly and open the water
supply tap.
2. Press the On/Off button to switch the
dishwasher on.
programme indicator lamps will
switch on.
3. Select the desired programme by
pressing the corresponding button.
corresponding indicator lamp lights
If required, select options (if supplied).
up.
4. Press the Start button to start the
selected programme.
indicator lamp will light up.
the programmed data cannot be
altered by pressing the programme
selector buttons.
once the Start button has been
Note:
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start
button for about 5 seconds, unt il
the Start indicator lamp
switches off.
programme using the
programme selector knob and
press the Start button.
If the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
lights up (for about 30 min.)
One of the
The
The Start
Once set,
Select a new
.
6. Once the Start indicator lamp has
switched off press the On/Off bu tton to
switch the dishwasher off.
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
All the
Upper rack
C
Half Load:
If the upper rack
the cutlery basket from the lower rack and
half
place it in the upper one.
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
• To lower: pull out the
handles and gently lower the rack.
is to be loaded, remove
only
side
two
Please read the user instructions carefully.
Upper and lower rack
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both
sides.
Crockery holders:
• Down:
cups and long-stemmed glasses.
•
Up: plates.
“Vario Organizer” multi-purpose
support:
• To be used, for example, for longhandled utensils
with the blade facing downwards),
cups and glasses.
• May be used in three different
positions (see also “Dishwasher
loading instructions” on Page 4).
1. Upon the left-hand side of the rack.
2. Upside-down, towards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
side handles
two
(arrange knives
Lower rack
Half Load:
Loading the lower rack
greater washing power, especially for
plates and saucepans.
only
gives
Cutlery basket (C):
• With or without handle (depending
on model).
• The cutlery basket can be removed
to increase available space.
Loading...