Whirlpool GSF 2989 WS INSTRUCTION FOR USE

GSF 2989

On / Off button

Before using the dishwasher, read the user instructions!

Quick Reference Guide

Wash cycle

GB

Programme selector

On / Off button

Switches “on” when the
dishwasher is operating. Flashes
when a fault occurs. Switches off
at the end of the programme.

Indicators

Add regeneration salt

only add regeneration salt
immediately before starting a
wash programme.

Add rinse aid
No water

check that the appliance fills with
water.

Programmes Loading instructions A B Litres kWh Minutes

Normal 40-55°C

Intensive 60-70°C

Pre-Rinse cold

Gentle 40°C

Rapid 30 min 40°C

Standard

Programme chart

Recommended programme for
routine washes, for crockery with
little dried-on food.

Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.

Crockery to be washed later. - - 4.0 0.03 14
Light soiling, for example

glasses and cups.
Lightly soiled crockery, with

no dried-on food.

1)

Normally soiled crockery. X X 14.0 1.05 110

50°C

Pre-wash Washing Drying

Options

Time and failure display

Indicates in hours the time remaining until
the start of the wash cycle. Switches off at
programme start and indicates the
remaining time in hours and minutes.

“F...” Information for the After-Sales
Service

“Delayed start” buttons

The wash cycle can be programmed to
start after 1 - 24 hours. Then press the
Start button. The dishwasher will start at
the set time.

“Half Load” button

This function can be used with any
programme. The indicator lamp switches
on: the wash cycle is activated for the
upper or lower rack

Detergent

X X 10-13 0.8-1.05 50-110

X X 13-20 1.1-2.0 90-140

X - 10.0 0.80 55

X - 10.0 0.65 30

2)

only

Consumption

Programme

end

3)

.

3)

1) Reference programme for energy label in
compliance with EN 50242 regulations;

2) Refer to “User instructions“;

3) Values may vary in relation to usage, e.g.:
different loads, water temperatures - above or
below 15° C - as well as water hardness and
power supply voltage, etc.

(We reserve the right to make technical modifications)

5019 496 90106

How to use the appliance

C

BA

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Press the ON/ OFF button.

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator lamp C.
Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator lamp D.
Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.

A:

B:

Select additional

options

Press the START button

Wash cycle

Switch off the appliance

shut off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator
lamp lights up.

The selected programme
is then memorised (even
in the event of power
failure).

Only after the START button has switched off: press the

OFF

ON /

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

button. All the indicator lamps switch off.

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;

Select another programme and
press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.