Whirlpool GSF 2956 WS, GSF 2956 SW INSTRUCTION FOR USE

GSF 2956

Before using the dishwasher, read the user instructions!

Quick Reference Guide

Wash cycle

Programme selector knob

On / Off button

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Indicators

Add rinse aid Add regeneration salt

Only add regeneration salt immediately before starting a wash programme.

No water

Check that the appliance fills with water.

Programme chart

Programmes Loading instructions A B Litres kWh Minutes

AutoNormal

AutoIntensive

Pre-Rinse cold

Pre-wash Washing Drying

Options

“Delayed start” button

The wash cycle can be programmed to start after 3-6-9 hours. Then press the Start button. The wash programme will start at the set time.

“Half load” button

This function can be used with any programme. The indicator lamp switches on. The wash cycle is activated for the upper

Detergent

Recommended programme for routine washes, for crockery with

40-55°C

little dried-on food. Recommended programme for

heavily soiled crockery, especially

60-70°C

suitable for pans and saucepans. Crockery to be washed later. - - 4.0 0.03 14

lower rack

X X 10-13 0.8-1.05 50-110

X X 13-20 1.1-2.0 90-140

Programme

end

only

Consumption

Glass 40°C

Rapid 30 min 40°C

Bio Normal

1) Reference programme for energy label in compliance with EN 50242 regulations;

2) Refer to “User instructions“;

Light soiling, for example glasses and cups.

Lightly soiled crockery with no dried-on food.

Normally soiled crockery. X X 13.0 1.24 128

50°C

X - 10.0 0.80 55

X - 10.0 0.65 30

3) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.

(We reserve the right to make technical modifications)

5019 496 90122

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Press the ON/ OFF button.

Large compartment With each wash cycle. Small compartment For programmes with pre-wash only.

Mechanical indicator lamp C. Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator lamp D. Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up. Select the desired programme (using the specific button or knob). The corresponding indicator lamp lights up.

Select additional

options

Press the START button

Wash cycle

Switch off the appliance

shut off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is then memorised (even in the event of power failure).

Only after the START button has switched off: press the

OFF

ON /

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

button. All the indicator lamps switch off.

“Change programme”

Press the START button for 2 sec. until the Start indicator lamp switches off;

Select another programme and press the START button again.

- Only open the dishwasher if necessary (Warning: beware of hot steam).

- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

+ 2 hidden pages