Whirlpool GSF 2778 SW, GSF 2778 WS INSTRUCTION FOR USE

GSF 2778

Before using the dishwasher, read the user instructions!

Quick Reference Guide

Wash cycle

GB

Programme selector knob

Pre-wash Washing Drying

Options

On / Off button

Start button

Switches “on” when the
dishwasher is operating. Flashes
when a fault occurs. Switches off
at the end of the programme.

Indicators

Add rinse aid
Add regeneration salt

Only add regeneration salt
immediately before starting a
wash programme.

No water

Check that the appliance fills
with water.

Programme chart

Programmes Loading instructions A B Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. - - 4.0 0.03 14

Time and failure display

Indicates in hours the time remaining
until the start of the wash cycle.
Switches off when the programme
starts and indicates the time remaining
in hours and minutes.

“F...” Information for the After­Sales Service

“Delayed start” button

The wash cycle can be programmed to
start after 1 - 24 hours. With each
successive touch of the button, the
delayed start indicator increases by 1
hour, and after 24 returns to 00. Then
press the Start button. The dishwasher
will start at the set time.

“Half load” button

This function can be used with any
programme. The indicator lamp
switches on. The wash cycle is activated
for the upper

Detergent

or

lower rack

2)

Consumption

Programme

end

3)

only

.

3)

Glass 40°C

Rapid 30 min 40°C

Bio/Eco 50°C

1)

Eco

Normal

Intensive

1) Reference programme for energy label in
compliance with EN 50242 regulations;

2) Refer to “User instructions“;

1)

Light soiling, for example glasses and cups. X - 10.0 0.80 55

Lightly soiled crockery with no dried-on food. X - 10.0 0.65 30

Normally soiled crockery. X - 10.0 1.30 75

Normally soiled crockery. X X 13.0 1,05 110

50°C

Normally or heavily soiled crockery. X X 13.0 1.45 90

65°C

Heavily soiled crockery, especially pots and

70°C

pans.

X X 20.0 2.00 125

3) Values may vary in relation to usage, e.g.:
different loads, water temperatures - above or
below 15°C - as well as water hardness and power
supply voltage, etc.

(We reserve the right to make technical modifications)

5019 496 90121

How to use the appliance

C

BA

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Close the door,

turn on the water tap

Select a programme

Press the ON/ OFF button.

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator lamp C.
Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator lamp D.
Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or
knob). The corresponding indicator lamp lights up.

A:

B:

Select additional

options

Press the START button

Wash cycle

Switch off the appliance

shut off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator
lamp lights up.

The selected programme
is then memorised (even
in the event of power
failure).

Only after the START button has switched off: press the

OFF

ON /

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

button. All the indicator lamps switch off.

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;

Select another programme and
press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.