Whirlpool GMX 61102 INSTRUCTION FOR USE

GBD NLF

Before using the dishwasher, you are advised to read the user instructions!

On/Off button

Press the button to switch on the dishwasher. The indicator light for the last programme to be selected lights up; at the end of the cycle the dishwasher emits a brief audible signal.

Programme selection button

Press this button to select the desired programme. The indicator light of the selected programme illuminates.

Indicator lights

Add regeneration salt

Only add regeneration salt immediately before starting a wash programme.

Add rinse aid

Options

Half load selector button

Press this button to select the half load option; the corresponding indicator light will illuminate. Press the button again to the deselect the option; the corresponding indicator light will go out. The half load function is suitable for smaller wash loads. The dishes should be distributed over both racks.

Antibacterial rinse (Sani Rinse option)

This function adds an antibacterial rinse at the end of the wash cycle, guaranteeing a further reduction of bacteria. The indicator light illuminates when the function is activated.

If the temperature is not maintained at a constant level during the antibacterial rinse programme (e.g. if the door is opened or there is a power cut), the programme indicator lights will flash to signal that the sanitizing effect of the antibacterial rinse is not guaranteed.

“Delayed start” button

The wash cycle can be programmed to start after 1-12 hours. The delayed start can be programmed either before or after selecting the desired wash programme. When the door is closed, a pre-wash cycle is run, after which the delayed start countdown begins.

Quick Wash

This option, when selected together with any wash programme (except pre-rinse ) SHORTENS THE DURATION of the selected wash cycle from a minimum of 10% to a maximum of 55%, depending on the programme selected. This function is activated by pressing the QUICK WASH button after having selected the desired programme.

Tablets selector

This setting allows you to optimize the wash cycle in accordance with the type of detergent used. If you use combined detergents that combine detergent, rinse aid and/or salt in 1 tablet Press the «Antibacterial rinse» + «Quick Wash» buttons simultaneously (the «Tablet» indicator light will illuminate). If you are using a powder or liquid detergent, the «Tablet» indicator on the control panel must be off.

QUICK REFERENCE GUIDE

NLFGBD

Fault indicators

Indicator lights

Off

Blinking

The water stop device has been activated

Switch off the appliance and contact After-Sales Service.

The dishwasher has filled with too much water

Reset and start the programme again from the beginning. If the problem persists, contact After-Sales Service.

Water heating system

Reset and start the programme again from the beginning. If the problem persists, contact After-Sales Service.

Water heating fault

Reset and start the programme again from the beginning. If the problem persists, contact After-Sales Service.

The dishwasher does not fill with water

Check the water supply and filters, and make sure that there are no kinks in the water inlet hose. Open and close the door in order to continue.

Water does not drain from the dishwasher

Make sure that the filter unit and drain hose are not clogged and if necessary clean them.

Turbine fault (if present) Reset and start the programme again from the beginning. If the problem persists, contact After-Sales Service.

Water filling system fault

Switch off the dishwasher and contact After-Sales Service.

NLFGBD

Programme Table Detergent

Consumption

Programmes Loading tips

A B

Litres kWh Minutes

(*)

Pre-wash cold

Dishes to be washed later.

_ _ 3,5 0,02 15

Delicate 45°C

Lightly soiled items, with no dried-on food.

X _ 9,5 1,10 65

Rapid 38°C

Light soiling, for example glasses and cups.

X _ 11 0,85 45

Eco

50°C Normally soiled items. X _ 10 1,03 165

Eco fast 60°C

Normally soiled items, without final drying.

X _ 12,5 1,25 70

Auto 60-70°C

Normally or heavily soiled dishes.

X X

(**) (**) (**)

Super 70°C

Recommended programme for heavily soiled dishes, ideal for pots and pans.

X _ 15,5 1,6 135

Intensive fast

65°C

Mixed soiling without dried-on food, without final drying.

X X 9,5 1,35 55

(*) If Pre-wash is selected, the supplementary functions will not be available. (**) If the “Auto”programme is selected, the wash cycle will be adjusted automatically according to how

dirty the dishes are.

1) Reference programme for energy label in compliance with Standard EN 50242 (upper rack adjusted in top position).

2) Refer to “User instructions”.

3) Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.

+ 5 hidden pages