Whirlpool ADL 961/1 WH, FUN 630 SW, ADG 343 WH, ADP 262 WH, FUN 630 BR User Manual
...
GB CONTENTS
BEFORE USING THE DISHWASHER
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
CONNECTIONS
ELECTRICAL CONNECTION
HOW TO FILL THE SALT CONTAINER
HOW TO FILL THE RINSE AID DISPENSER
HOW TO FILL THE DETERGENT DISPENSER
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
11
11
11
12
13
14
15
16
CARE AND MAINTENANCE
PAGE
17
To make the most of your new dishwasher, please read these user
instructions and the quick reference guide carefully.
10
BEFORE USING THE DISHWASHER
1. Removing the packaging and check
After unpacking, make sure that the
dishwasher is undamaged and that the door
closes correctly. If in doubt, contact a
qualified technician or your local retailer.
• Keep the packaging materials (plastic bags,
etc.) out of children's reach, as they are
potentially dangerous.
PROTECTING THE ENVIRONMENT
1. Packaging
The packing box may be fully recycled as
confirmed by the recycling symbol .
2. Energy and water saving tips
• Do not rinse crockery under running water.
• Always fully load the dishwasher before
switching on or set the wash programme to
half load (if available) if one rack only has
been filled.
2. Water and electrical connections
• All water and electrical connections must be
carried out by a qualified technician in
compliance with the manufacturer’s instructions
(refer to the enclosed assembly instructions)
and current local safety regulations.
The appliance must only be used in the
household for the prescribed uses.
• If ecological energy sources are available,
such as solar panel heating, heat pumps or
centralised heating systems, the appliance
may be connected to the hot water mains up
to a maximum temperature of 60° C. Make
sure the water inlet hose is of the correct
type. Refer to the “Connections” chapter in
these user instructions.
3. Disposal of the packaging material and
old machine.
The appliance is built from reusable
materials. If you decide to scrap the
dishwasher, it must be disposed of in
compliance with local waste disposal laws.
In any case, before scrapping, cut off
the power cable so that the appliance
cannot be connected to the mains.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
1. Child safety:
Children must not be allowed to play with the
dishwasher.
Store the detergent, rinse aid and salt in a
dry place out of the reach of children.
2. General recommendations:
The open dishwasher door can only support
the weight of the loaded rack when pulled out.
Do not rest objects on the open door or sit or
stand on it: the appliance may topple over!
Do not use solvents inside the dishwasher:
risk of explosion!
Only use detergents, rinse aids and
regeneration salts specially recommended
for use in domestic dishwashers.
• Before cleaning or carrying out any
maintenance, switch off the appliance,
disconnect the mains plug and turn off the
water tap.
• If a fault occurs, switch off the appliance and
turn off the water tap.
• If necessary, the power cable may be
replaced with an identical one.
The power cable must only be replaced by a
qualified technician.
• On completion of the programme, switch off
the dishwasher and turn off the water tap.
3. For appliances with water stop system:
The water inlet hose and plastic casing
contain electrical components. Do not
therefore cut the hose or immerse the plastic
casing in water. If the hose is damaged,
switch off the appliance immediately.
EC Declaration of conformity
This appliance has been designed, constructed
and distributed in compliance with the safety
requirements of EC Directives:
• 73/23/EC
• 89/336/EC
• 93/68/EC
• IEC 436/DIN 44990
• EN 50242
Load capacity: 12 place settings
.
11
CONNECTIONS
Do not use the dishwasher if it has been
damaged in transit. Consult our After-Sales
Service or your local retailer.
(Refer to the separate assembly instructions
booklet)
Water inlet and drain:
•
Observe any special regulations issued by
your local Water Board.
•
Make sure the inlet and drain hoses are kinkfree and are not crushed.
•
If the hose length is not sufficient, please
contact your local dealer or our After-Sales
Service.
•
The inlet hose must be securely clamped to
the water tap to prevent leaks.
•
The water inlet pressure should not be less
than 0.3 bars.
•
If the water inlet pressure is higher than
10 bars, a pressure reducing valve should be
fitted between the appliance inlet and the
water source.
•
The inlet water temperature varies according
to the model installed: inlet hose marked “25° C
Max”: maximum temperature 25° C.
All other models: maximum temperature 60° C.
•
When installing the appliance, make sure the
drain water discharges correctly (if
necessary, remove the wire gauze from
the sink siphon).
•
Fix the drain hose to the siphon with a clamp
to prevent it from coming off during operation.
•
For appliances with water-stop system only:
If the water connections are made correctly
according to the instructions, the water-stop
system safeguards your home against
damage caused by flooding.
Electrical connection:
•
Observe the current regulations issued by
your local electricity supplier.
•
Voltage information is shown on the rating
plate mounted inside the door on the right
hand side.
•
The appliance must be earthed as prescribed
by law.
•
Do not use extension leads or multiple
adapters.
•
Before carrying out maintenance, disconnect
the mains plug.
•
The power cable must only be replaced by a
qualified technician.
•
The manufacturer cannot be held
responsible for damage caused by incorrect
earthing of the appliance.
• For Austria:
connected to a fault current switch, this must
be sensitive to the pulsating current.
if the appliance is series
12
Loading...