Whirlpool FA90SF INSTRUCTION FOR USE
PRODUCT SHEET
1.
Compartment for freezing
2.
Control unit
3.
Area for drawers and pull out baskets/doors
4.
Pull-out defrost water drain
5.
Rating plate (on the inside of the appliance)
6.
Ice packs (if provided) - ice cubes.
storage compartment
freezer compartment
Note: the design of drawers and accessories may vary, depending on the model.
Controls
(depending on model)
GB
A
Thermostat knob.
B
Yellow LED: indicates that the fast freeze
function is in operation.
C
Red LED: indicates that the freezer internal
temperature is too high.
5019 603 01040
PL SK H RUS
D
Green LED: indicates that the appliance is
connected to the power supply.
E
Fast freeze button.
GBCZ
ROBG
Freezer compartment temperature adjustment
The appliance is normally factory set for optimum operation at a temperature of -18°C.
To adjust the compartment temperature, proceed as follows:
•
Turn the thermostat knob A to
•
Turn the thermostat knob A to
•
Turn the thermostat knob A to z to switch off the freezer (the appliance is still connected to the mains
1/Min
for a storage temperature that is less cold.
7/Max
for a colder storage temperature.
power supply).
Model with electronic thermometer
•
The LED indicates the highest temperature reached inside the appliance. For optimum food storage, set the
thermostat at a temperature of -18°C. The introduction of large amounts of food and frequent opening of the
door can temporarily affect the internal temperature of the appliance.
•
To deactivate the fast freeze function, press the button
(E)
; if the fast freeze function is not manually
deactivated, after approx. 48 hours the appliance will automatically deactivate it.
•
When the appliance is switched on, all the LEDs light up in sequence for a few seconds, after which the
appliance begins operation.
Alarm signals
Signal Cause Solution
Temperature alarm
The red LED lights up
C
The internal
temperature is above
-12°C
Press button E until the
temperature returns
below -12°C again
Defrosting
1.
To switch off the freezer, turn knob A.
2.
Unplug the appliance or switch off at the main
switch.
3.
Fit the drain in place (see figure).
4.
Follow the instructions given in the
instructions booklet.
5.
Plug in the appliance once again.
6.
To switch on the freezer again, turn knob A. Follow the steps detailed in “Switching on the
appliance”.
5019 603 01040
PL SK H RUS
GBCZ
ROBG
Printed in Italy 03/09
Loading...