Whirlpool EV 944 INSTRUCTION FOR USE
GB
Cotton with prewash
Synthetic with prewash
Synthétique avec prélavage
Delicate with prewash
Délicat avec prélavage
Rinçage + Essorage doux
EV 944
Programme
Coton avec prélavage
Cotton
Coton
Coloured
Couleur
Synthetic
Synthétique
Short
Court
Delicate
Délicat
Wool
Laine
Silk
Soie
Rinse + Gentle Spin
Rinse + Spin
Rinçage + Essorage
Spin
Essorage
Gentle spin
Essorage doux
Drain
Vidange
Care
Labels
—
—
—
—
—
A
Type of wash / Notes
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and
linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Same as the last two rinses and the final spin in the “Synthetic” programme. P
with starch or softener.
Same as the last rinse and the final spin in the “Cotton” programme.
Programme for treating wash with starch or softener.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
CB
N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.
A. Temperature Selection Knob
B. “Spin Speed Selection” Knob
C. “On/Off” Button
Max.
load
kg
5.0
2.0
1.5
5.0
3.0
2.0
1.5
1.5
1.0
1.0
rogramme for treating wash
2.0
5.0
5.0
2.0
—————————
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted to
700 rpm in this programme.
3)
For improved garment care, spin speed is zero in this
programme.
Prewash Main
Detergents and additives Special Options Tempera-
Wash
1)
Yes
Yes
Yes
—
—
—
—
—
—
—
Yes
1)
Yes
1)
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
——
——
Softener Bleach Int e nsive
Rinse
Rinçage
Intensif
Rinse
Hold
Arrêt Cuve
Pleine
❉❉❉ ❉
❉
❉
—
——
❉❉
❉
❉❉❉ ❉
❉
❉
❉
❉
❉
❉
❉
❉
—
—
—
——
——
——
——
——
❉❉
❉❉
❉❉
❉
❉
❉
❉
❉
ture
°C
Max. 90 900
Max. 60
Max. 40
Max. 90 900
Max. 60 900
Max. 60
Max. 60
Max. 40
Max. 40
Max. 30
—
—
————— — —
————— — —
Laden is a registered trademark
5019 612 00116
Max.
Spin
Speed
rpm
700
700
700
700
700
700
—
700
900
900
700
2)
2)
2)
2)
2)
2)
3)
2)
2)
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5.0 63* 1.80 2:05
Cotton 60 5.0 59 0.95 2:05
Cotton 40 5.0 59 0.55 2:05
Synthetic 60 2.0 56 0.80 1:35
Synthetic 40 2.0 50 0.40 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the
table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60° C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE
1. Load the machine, close the drum flaps and check
that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
“MAX”
level mark, as
follows:
“Intensive Rinse” button
• One rinse cycle is added to ensure a more
intensive rinse.
• This option is particularly suitable for areas with
very soft water, washing baby linen and people
with detergents allergies.
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
desired temperature.
5. Turn the
spin speed selector knob
to the desired
spin speed. If the spin speed “ ” is selected, the final
spin is cancelled, but not the intermediate spins. The
programme ends with a drain cycle.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic” or “Delicate” programmes.
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Remark:
The programme selector knob stop on
“”.
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
programme will terminate automatically with
the selected spin cycle.
• If you do not wish to spin the clothes, press the
“On/Off”
button, turn the programme selector
knob to the “Drain” programme and press the
“On/Off”
button again.
PROGRAMME START
Turn on the tap and press the
indicator light of the
Note
: If there is a power interruption or if the
“On/Off”
“On/Off”
button. The
button lights up.
appliance is disconnected during the cycle, the
programme will run again from the point where it was
interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop
position.
1. Press the
“On/Off”
button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the door to unlock (about 1 minute).
Open the door and the drum flaps and unload
5.
the machine.
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
1. Switch off the machine by pressing the
“On/Off”
button.
2. Select the new programme.
3. Start programme by pressing the
“On/Off”
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the
“On/Off”
button.
2. After the desired pause, press again the
“On/Off”
button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
“On/Off”
button.
2. Set the programme selector to “Drain”.
3. Press the
“On/Off”
button again to start the
“Drain” programme.
SELECT THE DESIRED OPTION
Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.
Laden is a registered trademark
5019 612 00116
Loading...