Whirlpool EV 845 INSTRUCTION FOR USE
GB
EV 845
A. “On/Off” Button
B. “Spin Speed Selection” Knob
AB
Programme
Cotton with prewash
Synthetic with prewash
Delicate with prewash Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Cotton 90°-60°
Coloured 40° Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and linen.
Synthetic 60°
Short 40° Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.
Delicate 40° Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Wool 40°
Silk
Rinse + Gentle Spin
Rinse + Spin —
Spin —
Gentle spin —
Drain —
N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.
Care
Labels
—
Type of wash / Notes
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends
with cotton.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or
blends with cotton.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Same as the last two rinses and the final spin in the "Synthetic" programme. P
softener.
Same as the last rinse and the final spin in the “Cotton” programme.
Programme for treating wash with starch or softener.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
rogramme for treating wash with starch or
1)
Do not use liquid detergents.
3)
For improved garment care, spin speed is zero in this
programme.
Max.
load
kg
5.0
2.0
1.5
5.0
3.0
2.0
1.5
1.5
1.0
1.0
2.0
5.0
5.0
2.0
Detergents and additives Special Options Max.
Prewash Main
Yes
Yes
Yes
Wash
1)
1)
1)
—
—
—
—
—
—
—
——
——
Softener Bleach Intensive
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
❉❉❉ ❉
❉
❉
❉❉❉ ❉
❉
❉
❉
❉
❉
❉
❉
❉
Rinse
Rinçage
Intensif
—
❉❉
——
—
—
—
❉❉
❉❉
❉❉
——
——
——
——
——
Rinse
Hold
Arrêt Cuve
Pleine
❉
❉
❉
❉
❉
❉
——— — — —
——— — — —
Spin
Speed
rpm
800
800
800
800
800
800
800
800
800
—
800
800
800
800
2)
———— — — — —
Laden is a registered trademark of Whirlpool USA.
5019 612 00021
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5.0 63* 1.80 2:05
Cotton 60 5.0 59 1.15 2:05
Cotton 40 5.0 55 0.55 2:05
Synthetic 60 2.0 56 0.80 1:35
Synthetic 40 2.0 50 0.40 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the
table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum flaps and check
that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
“MAX”
level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
spin speed selector knob
to the desired
spin speed. If the spin speed “” is selected, the final
spin is cancelled, but not the intermediate spins. The
programme ends with a drain cycle.
Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.
“Intensive Rinse” button
• One rinse cycle is added to ensure a more
intensive rinse.
• This option is particularly suitable for areas with
very soft water, washing baby linen and people
with detergents allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to avoid
creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic” or “Delicate” programmes.
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want to
drain only.
Remark:
The programme selector knob stop on “”.
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
programme will terminate automatically with
the selected spin cycle.
• If you do not wish to spin the clothes, press the
On/Off
“
” button, turn the programme selector
knob to the “Drain” programme and press the
On/Off
“
” button again.
PROGRAMME START
Turn on the tap and press the “
indicator light of the “
Remark
: If there is a power interruption or if the
On/Off
On/Off
” button. The
” button lights up.
appliance is disconnected during the cycle, the
programme will run again from the point where it was
interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop
position.
1. Press the “
On/Off
” button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the door to unlock (about 1 minute).
Open the door and the drum flaps and unload
5.
the machine.
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
1. Switch off the machine by pressing the “
Off
” button.
On/
2. Select the new programme.
Start programme by pressing the “
3.
On/Off
”
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
button.
On/Off
” button.
“On/
1. Press the “
2. After the desired pause, press again the
Off”
CANCEL PROGRAMME
1. Switch off the machine by pressing the “
Off
” button.
On/
2. Set the programme selector to “Drain”.
3. Press the “
On/Off
” button again to start the
“Drain” programme.
Laden is a registered trademark of Whirlpool USA.
5019 612 00021
Loading...