Whirlpool EV 7096, BLZH 4006 WS, BLZH 4006 IN, BLZH 4006 CR IN, BLZH 4006 AL INSTRUCTION FOR USE

GB EV 7096
A B
A. Programme Selection Knob B. “On/Off” Button
i : option / Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is null
in this programme.
Max.
Programme
Cotton with prewash Prélavage Coton Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. 5,0 Yes 1)Yes
Synthetic with prewash Prélavage Synth.
Delicate with prewash Prélavage Délicat Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5 Yes 1)Yes
Cotton
95º - 60º - 40º
Daily Mixed Slightly to normally soiled textiles made of cotton and/or synthetic. 3,0 Yes
Synthetic 40° Synthétiques 40°
Delicate 40° Délicat 40° Curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5 Yes
Wool 40° Laine 40°
Silk 30° Soie 30°
Rinse + Gentle
Spin
Rinse + Spin Rinçage et essorage Programme for treating cotton or linen laundry with starch or softener. 5,0
Spin Essorage Programme to spin cotton or linen laundry intensively with maximum spin speed. 5,0
Gentle Spin Essorage court Programme to spin delicate laundry gently with a restricted spin speed. 2,0
Drain Vidange Drain only - no spinning. Alternative method of terminating programme after „Rinse Hold“.
Coton
95° - 60° - 40°
Rinçage et essorage
courts
Care
Labels
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen,Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select „Rinse Hold“ do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as „handwashable“.
If you select „Rinse Hold“ do not leave items to soak for too long. No spinning.
Programme for treating delicate laundry with starch or softener. 2,0
Type of wash / Notes
load
kg
2,0 Yes 1)Yes
5,0 Yes
2,0 Yes
1,0 Yes
1,0 Yes
Detergents and Additives Special options Max.
Pre-
Main
wash
Softener Bleach Bi-
wash
i i i i i
i
i
i i i i i
i
i
i
i
i
i
i
Intensive
speed
Rinse
700
Rinçage
400
intensif
i i i
i
i i i
i i i
i
i
i
i i i
i i i
i
i
700
700
Rinse Hold
Arrêt cuve
pleine
i
i
i
i
Spin
Speed
rpm
700
700
700
700
700
700
700
700
2)
700
700
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
5019 612 10102
CONSUMPTION DATA
Programme
Temperature
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 95 5,0 63* 1,80 2:05 Cotton 60 5,0 59 0,95 2:05 Cotton 40 5,0 59 0,55 2:05
Daily Mixed 40 3,0 49 0,48 1:00
Synthetic 60 2,0 56 0,80 1:30 Synthetic 40 2,0 56 0,45 1:20
Delicate 40 1,5 60 0,55 0:45
Wool 40 1,0 60 0,50 0:40
Silk 30 1,0 60 0,30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard EN/IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and check that they are properly locked.
2. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3. Turn the programme selector knob to the desired programme.
Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Bi-speed” button
Press button to set the spin speed. Note: every programme has an automatic
maximum spin speed.
“Intensive Rinse” button (Rinçage intensif)
The amount of water is increased to ensure
a more intensive rinse.
This option is particulary suitable for areas with very soft water or washing linen laundry for people with skin allergies.
“Rinse Hold” button (Arrêt cuve pleine)
The laundry remains in the last rinse water
without progressing to the final spin cycle to avoid creasing and prevent colours from fading.
This option is particularly recommended for the “Synthetic”, “Delicate” and “Daily Mixed” programmes.
This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.
Note: The programme selector knob stops on . Appliance in “Rinse Hold”:
Pres s the “Rinse Hold” button again: the
programme will terminate automatically with the selected spin cycle.
If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again.
PROGRAMME START
Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.
END OF WASH CYCLE
The programme selector knob is in the Stop
position.
1. Press the “On/Off” button to switch off the machine.
2. Cancel the option.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drun doors and unload the machine.
CHANGE THE PROGRAMME DURING THE WASH CYCLE
1. Switch off machine by pressing the “On/Off” button.
2. Select the new programme.
3. Start programme by pressing the “On/Off” button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the programme for a certain time and continue it later:
1. Press the “On/Off” button.
2. After the desired pause, press again the “ON/Off” button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the “On/Off” button.
2. Set the programme selector to “Drain”.
3. Press the “On/Off” button again to start the “Drain” programme.
5019 612 10102
Loading...