Whirlpool EV 4011 INSTRUCTION FOR USE
GB
EV 4011
PROGRAMME TABLE
Programme Selector
1/2 Load Option
On/Off
Programme Type of fabrics / Degree of soiling / Notes Max.
Cotton with Prewash
Prélavage
Cotton 90°
Coton 90°
Cotton / Coloured 60°
Coton / Couleurs 60°
Synthetics 40°
Synthétiques 40°
Rinse + Spin
Rinçage
Spin
Essorage
Delicate
Fragile
Wool
Laine
Rinse + Spin
Rinçage
Spin
Essorage
Drain
Vidange
Heavily soiled sheets, tablecloths, underclothes, shirts etc. in hard
wearing and high temperature resistant cotton.
The maximum load for heavily soiled washing is 3.5 kg.
Moderately soiled sheets, tablecloths, underclothes, towels etc. in hard
wearing and high temperature resistant cotton.
Moderately soiled sheets, tablecloths, underclothes, towels etc. in hard
wearing and temperature resistant cotton.
Lightly soiled shirts, blouses etc., made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or cotton blends.
This programme allows starch or softener to be added.
It is followed by an intensive spin cycle.
Programme for intensive spin cycle. 5.0
Delicate fabrics and curtains (dresses, skirts, shirts, blouses, etc.). 1.5
Machine washable woollens with pure new wool label.
If the “Rinse Hold” option is selected don't leave t he wash to soa k for too long.
This programme allows starch or softener to be added.
It is followed by a gentle spin cycle.
Programme for gentle spin cycle. 1.5
Drain only, without spin cycle.
Alternative way to end programmes after a “Rinse Hold”.
Load
wash
kg
5.0 Yes Yes
5.0
5.0
2.0
5.0
1.0
1.5
—— —
Detergent and Additives Option Temperature
Pre-
Washing Softener Bleach Half Load
—
—
—
——
—— —— — —
—
—
——
——
Yes
Yes
Yes
Yes
Yes
❉❉ ❉
❉❉ ❉
❉
❉
❉
❉
❉
❉
—
—
—
—
—
——
——
——
—— —
—— — —
❉
❉
❉
(1)Programme duration
figures (guideline) are
valid for maximum
temperature wash with
no special functions.
Maximum Spin
Speed
°C
90 400 130
90 400 115
60 400 90
40 400 70
Cold 400 20
40 400 55
30 400 45
Cold 400 15
rpm/min
400 10
400 5
Programme
time
approx.
min (1)
3
N.B.: The excess of detergent in the dispenser could cause technical problems.
5019 100 01002
GB
ENERGY AND WATER CONSUMPTION DATA
Programme Temperature
(°C)
Cotton 90° 90 5.0 72 1.80 115
Cotton / Coloured 60° 60 5.0 70 1.20 90
Synthetics 40° 40 2.0 66 0.35 70
Delicate 40 1.5 70 0.65 55
Wool 40 1.0 70 0.55 45
Programmes with prewash last about 15 minutes more than programmes without prewash. Water and energy
consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual
consumption may vary in comparison with the values specified in the table, because of differences in supply water
pressure and temperature, the load and the type of wash.
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
ADDING DETERGENT AND ADDITIVES
Pour the detergent and additives into the respective
compartments as follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and starch
• Bleach
• Stain removers
• Anti-scale agents (water hardness 4)
Important Note:
• Do not fill beyond the “
MAX”
level mark.
• For programme with prewash: do not use liquid detergent.
• For programmes without prewash from cold to 40° C, it is recommended to use a liquid
detergent to avoid whitish residues on the coloured laundry.
CLOSE THE DOOR AND SELECT THE PROGRAMME
• Turn the
programme selector knob
clockwise to the desired programme.
PRESS ANY DESIRED OPTION BUTTON(S)
“Half Load” button
• Reduces the water consumption in the “Cotton” and “Synthetic” programmes
especially during the rinse.
• Especially suitable for lightly soiled or small loads (reduce the quantity of detergent).
• Not suitable for high temperature programmes.
PROGRAMME START
Open the water inlet tap and press the On/Off button “ ”. The pilot lamp lights up.
DOOR LOCK
During the running programme, the door cannot be opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical power failure occurs, the door unlocks
automatically after about 1 minute.
PROGRAMME END
• The programme selector knob“ ” is at “STOP”.
1. Press the On/Off button “ ”. The pilot light goes out.
2. Cancel the options by pressing the appropriate buttons.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload the machine.
SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER
PROGRAMME START
1. Press the On/Off button “” to switch off the appliance.
The pilot light goes out.
2. Select the new programme and options.
3. Press the On/Off button “ ” to switch on the appliance.
The pilot light lights.
TO STOP, RESET A PROGRAMME BEFORE THE END
1. Press the On/Off button “ ” to switch off the appliance.
The pilot light goes out.
2. Set the programme selector “ ” on “Drain”.
3. Press the On/Off button “ ” to start the “Drain” programme.
Only open the door when the programme selector “ ” is at “STOP” and
the door is unlocked (after approximately 1 minute).
5019 100 01002
Loading...