Whirlpool EV209NBTQ Dimension Guide

Upright Freezer

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

LOCATION REQUIREMENTS

EV209NBT

Electrical: A 115-volt, 60-Hz, AC-only, 15­or 20-amp fused, grounded electrical supply
is required. It is recommended that a
separate circuit serving only your refrigerator
be provided. Use an outlet that cannot be
turned off by a switch. Do not use an
extension cord.

Water: A cold water supply with water
pressure between 30 and 120 psi (207 and
827 kPa) is required to operate ice maker and
water dispenser. If you have questions about
your water pressure, call a licensed, qualified
plumber.

Reverse Osmosis Water Supply: If a reverse
osmosis water filtration system is connected
to your cold water supply, the water pressure
to the reverse osmosis system needs to be a
minimum of 40 to 60 psi (276 to 414 kPa).

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

Ref. W10326800B

3/25/11

IMPORTANT: Do not install the freezer near an oven, radiator, or other heat
source, nor in a location where the temperature will fall below 40°F (5°C).

Check the strength of the floor before installing your freezer. It should hold the
weight of a freezer fully loaded with food.

Allow at least 3" (7.5 cm) of air space at the top and on both sides of the
freezer and 1" (2.5 cm) between the back of the freezer and the wall. If the
freezer is to be against a wall, leave extra space on the hinge side so the door
can open wider.

NOTE: This freezer may be installed side by side with another refrigerator or
freezer. Allow for a 3" (7.5 cm) clearance at the top and sides and a ¹⁄₄"
(0.64 cm) clearance between the appliances.

Depth 30”

Width 33”

Height 67”

D

H

W