UPRIGHT
FREEZER
Model EVISOFXR
,, Freezers. Refrigerator-Freezers Ice Makers. Olshwashers. Built-In Ovens and Surface Units. Ranges. MIcrowave Ovens. Trash Compactors, Room Air Condltmners, Oehumtdlfll
Please read this
Use and Care Guide
before you do anything else...
This booklet tells you how to start your freezer,
defrost it, clean it and adjust controls
Treat your new freezer with care. Use it only to
do what home freezers are designed to do
Parts
Interior !
Light
Temperature
Control
Power Saving
Control
Trivet \
and features
5
Stationary
. Key Eject
Lock
Signal
/ Ligh+
Model and
Serial Number
Plate
Copy your Model and Serial Numbers here...
Nher <!x.
have this infor ylut .Jr; ready
1. Complete Mode ovd Serlal Numbers (fron-1 the
plate lokatec us showr,)
2. Purchase a Jte ‘ram sales slop
Copy this II formatlor~ In these spaces Keep this
book, your &Irranty and sales slip together In a
handy place rhere IS no warranty registration to re-
turn Proof-of~:xxchose IS all that IS required for ins
warranty serv :e
2
t+~‘; serYlce, or call wth a question
Model Number
Serial Number
Purchase Date
Service Company and Telephone Number
SAFETY FIRST
BEFORE YOU PLUG IT IN
Install Properly
Level Freezer
Remove Sales Labels
Clean It
Plug It In
USING YOUR FREEZER.
Setttng the Temperature Control
Adjusting the Temperature Control
Cooltng Freezer First
The Power Saving Control
Changing the Light Bulb
Removtng the Bottom Trivet
The Key Eject Lock
Energy Saving Tips
Paae Page
-3 TheSignal Light
CLEANING YOUR FREEZER’ 3
4
Cleaning Chart
4 FREEZING FOOD IN YOUR FREEZER.
4
Packaging and Sealtng Food
4
To Wrap Foods
4
Loading
5 Storing Frozen Food
5 VACATION AND MOVlNG’bARE
5 Vacattons
5 Shutiing Off and Moving
5 IF YOU NEED SERVICE OR ASSISTANCE
5
1 Before Calling for Assistance
6 2 If You Need Assistance
6 3 IfYouNeedServlce
6
4 If You Have a Problem
c 1985 Whtrlpool Corporation
I
8
8
8
9
9
10
10
Before you plug it in
IMPORTANT
Before using your freezer, you are personally re-
sponstble for maktng sure that It
IS tnstalled and levelled on o floorthat will hold the
weight, and In an area suitable for Its stze and use
IS connected only to the right kind of outlet, with the
right electrical supply and grounding [Refer to
your “Electrical Requirements and Grounding
Instructions”)
IS used only for jobs expected of home freezers
IS not near an oven, radiator or other heat source
l
IS not used by those who may not understand
L -
Install properly...
& n
3 Inches
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then
remove
OR
2 Soak area with dlshwashing detergent solution (1
teaspoon detergent In 1 quart worm water) bofore removing glue as described In step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, carbon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
A
1 Check the strength of the floor It should hold the
weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3
Allow 3 Inches, 7 5 cm) olr space on top of freezer
for proper ventMotion
4 Allow at leas’ on Inch (2 5 cm] Detweer the
freezer condeclser on the bock of the unit and
the wall
5 Allow II, Inch [” 25 cm) on each side of the freezer
for ease of insi .~llation
6 If the freezer II to be against a wall, yod might
want to leave extra space on the hinge side so the
door can be coened wider
Level freezer...
Clean
Clean your freezer before
using it See clearrlng
instructIons on page 7
it . . .
Plug it in...
J-prong groundir
type wall receptacle
Retainipg Clip
Raise
Start adjustment with the door hinge side.
1 Slide freezer InI3 place
2 Adjust front legs to level the freezer
To raise front, lurrl each leg clockwIse
To lower front turc each leg counTer-clockwise
3 Check with level
4 After freezer
A
IS
f 1lly loaded recheck with level
Freezer
Power Plug
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrlcal supply is required.
It IS recommended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package Inside the freezer.
/
grounding plug
Recommended Grounding Method