Whirlpool ETPV 5760 IN, ETIH 5660 IN, ETIV 5760 IN, ETPS 5660 IN INSTALLATION

41902034GB.fm Page 11 Monday, October 11, 2010 11:25 AM

INSTRUCTIONS FOR
USE

BEFORE USING THE GLASS CERAMIC
HOB

INSTALLATION
ELECTRICAL CONNECTION
ENERGY SAVING TIPS
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL

RECOMMENDATIONS
COOKTOP ACCESSORIES
CARE AND MAINTENANCE OF THE

GLASS-CERAMIC COOKTOP
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE

11

41902034GB.fm Page 12 Monday, October 11, 2010 11:25 AM

BEFORE USING THE GLASS CERAMIC HOB

• To make the most of your new appliance,

please read the user instructions carefully and
keep them to hand for future consultation.

INSTALLATION

Cooktop

• The cooktop must be set into a worktop between
20 mm and 50 mm deep.

• There must be nothing between the cooktop and the
oven (cross rails, brackets, etc.).

• The distance between the lower face of the glass
ceramic hob and the cupboard or separating panel
must be at least 50 mm.

• If the cooktop is to be installed next to a column unit,
leave a distance of at least 100 mm from the edge of the
cooktop.

• Make an opening in the worktop of the dimensions shown in

the Product Description Sheet supplied separately.

• Apply the supplied gasket to the cooktop (unless it has already
been fitted), after having cleaned its surface.

Important

In order to prevent the electronic circuits from overheating, and
therefore from being damaged, we recommend the following:

• Do not install the cooktop near the dishwasher or
washing machine, so that the electronic circuits are not
in contact with steam or moisture, which could damage
them.

• Make sure that the oven (produced by us) has a cooling
fan to protect electronic parts as much as possible if the
cooktop is installed above it.

If the temperature of the electronic circuits exceeds the
maximum permitted temperature, the cooktop will switch off
automatically; in this case, wait for a few minutes until the
internal temperature of the electronic circuits reaches a tolerable
level, at which point it will be possible to switch the cooktop on
again.

• Do not forget to switch the cooktop off. Should you
inadvertently forget to switch it off, the cooktop is
provided with an automatic switch-off feature after 1 to
6 hours of operation, depending on the cooking level
selected.

12

41902034GB.fm Page 13 Monday, October 11, 2010 11:25 AM

INSTALLATION

Assembly

A) If the worktop is made of wood, use the supplied spring

clips and screws.

• Position the 4 clips (A) as shown and at the specified
distance.

• Secure the clips using the 4 screws (B).

• Fit the cooktop in the prepared worktop (see figure).

B) If the worktop is made of marble or other materials

(plastic compounds, ceramics, stone, etc.), the cooktop

must be fitted by means of brackets code 4819 404 78697
(to be requested from the After-Sales Service).

• Position the cooktop into the prepared worktop.

• Position the 3 brackets (C) as shown in the figure, in

accordance with the thickness of the worktop.

• Secure the three screws (E) in the holes (D).

13