Whirlpool EL88TRRWQ, EL88TRRWS, EL88TRRW Dimension Guide

All Refrigerator

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

LOCATION REQUIREMENTS

EL88TRRW

Electrical: A 115-volt, 60-Hz, AC-only, 15­or 20-amp fused, grounded electrical supply
is required. It is recommended that a
separate circuit serving only your refrigerator
be provided. Use an outlet that cannot be
turned off by a switch. Do not use an
extension cord.

NOTE: Before performing any type of
installation, cleaning, or removing a light
bulb, turn the control (Thermostat,
Refrigerator or Freezer Control depending on
the model) to OFF and then disconnect the
refrigerator from the electrical source. When
you are finished, reconnect the refrigerator to
the electrical source and reset the control
(Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired
setting. See “Using the Controls.”

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

Ref. W10326802A

7/27/12

This refrigerator may be installed side by side with another refrigerator or
freezer. Allow at least 1" (2.54 cm) between back of cabinet and the wall.

If you are installing your refrigerator next to a fixed wall, leave extra space on
the hinge side to allow for the door to swing open.

NOTE: It is recommended that you do not install the refrigerator near an oven,
radiator, or other heat source, nor in a location where the temperature will fall
below 55°F (13°C).

Model Size

Height - Overall

“A”

Depth - Without

Handles

“B”

Width - Cabinet

“C”

17.7 cu.ft. 665⁄8" (169.2 cm) 281⁄2" (72.4 cm) 30" (76.2 cm)

A

overall

C

not incl.

handle

B

4