Whirlpool DWH C10 W, DWH C40 W, DWH C00 W INSTRUCTION FOR USE

QUICK REFERENCE GUIDE

Attention

Please read the operating manual prior to operating the machine for the first time.

On/Off button

Rinse aid level indicator light

Salt level indicator light

tart/Pause button

Programme selection button

How to use your dishwasher:

Open the water tap. Plug to the mains. Open the door and load the dishwasher. Check if both upper and lower spray arms move freely. Pour (Put in) the detergent. Push in the on/off button and check that the display lights comes on. Check the salt and rinse aid level indicators before you start the machine. If necessary add salt and rinse aid. Use the programme selection button to choose your washing programme.

2 3

Start the programme with the start / pause button: Close the door then programme starts.

Attention

Avoid opening the door during the washing process. This interrupts the washing process, and hot steam will escape. When the door is closed, the programme will continue.

An audio signal with an interval of 10 seconds warns you to switch your machine off when the selected washing program ends. This audio signal

warns you for a duration of 5 minutes and then turns off. Open the door Press the on/off button after the programme is completed. The indicator lights will go off. Close the water tap. Pull out the plug. Allow your dishes to cool for 15 minutes, with the door open.

Unload the dishes. Begin with the lower basket.

PROGRAMME TABLE

Programme number

Programme name

Cleaning temperature

Suited to

Degree of dirtiness

Detergents

15 cm³

15-25 cm³

+ 5 cm³

Programme process

Duration (min)

Energy (kWh)

Water (I)

The consumption values shown in the table were determined under standard conditions. For this reason, deviations are possible under practical conditions.

** Reference programme für test institutes

The tests in accordance with EN 50242 must be carried out with a full salt container of the water softener, a full reservoir for the rinse aid and the testing programme. Load capacity : 10

Pre-wash

Used dishes

which are to be

washed at a later

time

Pre-wash

End

3,6

30 Min.

35°C

Dessert and

coffee dishes with

food leftovers which are not

dried on

Few

35°C wash

Cold rinse

End

0,75

10,2

Reference **

Eco

50°C

Normally dirty

dishes with starch

containing food leftovers which

are not dried on

medium

Pre-wash

50°

wash

Clear rinse

Dry

End

140

1,01

Normal

60°C

Normally dirty

dishes with food

leftovers which

are not dried on

medium

Pre-wash

60°

wash

Clear rinse

Dry

End

1,02

13,2

Intensive

70°C

Especially dirty

dishes with food

leftovers which

are dried on

High

50°C

Pre-wash

70°

wash

Cold rinse

Dry

End

110

1,32

15,2

FUNCTION BUTTONS

Function buttons Control indicator lights

On/off button

You turn your dishwasher on / off with this button. When turning on, the indicator light for the last used programme will light up.

Start / Pause button

You use this button to start the selected programme; the light on the button lights up. Stop the programme with the start / pause button if you would like to open the door once the dishwashers washing programme is running.

Programme selection buttons

Use the programme selection button to select the desired programme. The corresponding programme light lights up.

How to cancel the washing programme

To cancel a programme while the machine is operating: Press start/pause button. The indicator light will go off. Press start/pause button for 5 seconds again. The indicator light will start flashing. Close the door. The machine will drain the water inside the machine for 45 seconds. The programme is cancelled when start/stop indicator light goes off. Then, you can choose and start a new programme.

! Important: Depending on the stage of the programme you have cancelled, there may be detergent residue or rinse aid inside the machine and on the load. Make sure the items in the dishwasher are not used before washing properly.

How to change the washing programme

To change the programme selection while the machine is operating open the door.

Press start/pause button. The indicator light will go off. Select the new programme. Press start/pause button. The

indicator light will be on and close the door new programme will start.

! Important: The new programme will NOT start right from the beginning. It will start from the stage last carried out by the previous programme selection.

Rinse aid level indicator light

2 3

If this indicator light comes on, you have to refill rinse aid. You can also tell whether rinse aid must be refilled by looking at the rinse aid dispenser. When the visual fill indicator is dark, there is enough rinse aid in the dispenser. When the colour is light, open the dispenser and refill rinse aid.

Salt level indicator light

Attention

- Depending on the length of the terminated programme

- detergent and rinse aid may still be in the dispensers.

2 3

When this indicator light comes on, you must refill special salt. In machines which do not possess an electrical salt indicator, the salt content can be read on the container for the salt. When the visual fill indicator is dark, there is enough salt in the container.

When the colour is light, open the container and add dishwasher salt.

Note for Testing Institutes

The necessary information for performance testing will be provided upon request. The request can be done by e-mail through:

dishwasher@standardloading.com

Please do not forget to write the model code and stock code information of the appliance besides your contact information in the e-mail. The model code and stock code information can be found on the rating label, which is placed on the side of the door.

Full

Empty

17 2486 01 00-005019 696 94700