Whirlpool DU7216XS, DU7200XS User Manual

DISHWASHER
Undercounter Models DU7200XS DU72l6XS
‘zers Ice Makers O~shwashers Bwll-In Ovens and Surface Uwts Ranges Mwowave Ovens. Trash Compactors Room Au Condwxws Oehumldlllers Aulomallc Washers. Clolhes Oryers Freezers. Re
Contents
The Filtering System. Quiet Operating Tips
PROPERLOADING..................
Top Rack Loading Bottom Rack Loading Silverware Basket Loading
ADDING DETERGENT
Page
2
BEFORE STARTING YOUR DISHWASHER. STARTING YOUR DISHWASHER,
Selecting a Cycle
HEATDRYorAIRDRY ..,.,,...,........ 9
Changing a Setting
To Add a Dish After Starting ENERGY SAVING TIPS SPECIAL TIPS COMMON DISHWASHING PROBLEMS.. IF YOU NEED SERVICE OR ASSISTANCE WHIRLPOOL DISHWASHER WARRANTY
01988 Whirlpool Corporation

Before you use your dishwasher

It is Your personal responsibility and obligation to be sure your dishwasher:
l
Is installed by a qualified installer.
l
Has been installed where it is protected from the elements.
l
Has been installed on a floor strong enough to support its weight.
l
Has been properly connected to electricity, water and drain?
l
Has been properly electrically grounded.*
l
Has had all hang tags and temporary labels removed.
l
Is not used by children or anyone unable to operate it properly.
l
Is properly maintained.
‘See installation instructions for complete information.
Page
8 8 8
9
9 10 11 12 14 16

Parts and features

Models DU7200XS and DU72l6XS
RACK BUMPER
DETERGENT DISPENSERS
USER GUIDE (Permanent Label)
/
HEATING ELEMENT
m\\Pump Guard) ,
I
FILTER SYSTEM (Screen and Removable
PANEL ACCESS
LOWER SPRAY ARM
SILVERWARE BASKET
MODEL AND SERIAL
e
THE OVERFLOW PROTECTOR is designed to prevent too much water
from entering the dishwasher. It is not removable.
CoLoR pANEL/shT
SPRAY TOWER
NUMBER PLATE
(not shown)
Copy your Model and Serial Numbers here...
When you need service or call with a question,
hove this information ready:
1. Complete Model and Serial Numbers (from the plate located as shown).
2. Purchase dote from soles slip Copy this information in these spaces. Keep this
book and your soles slip together in o handy place.
Thank you for purchasing a Whirlpool prod-
uct. Please complete and mail the Owner Regis-
tration Card furnished with this product.
Model Number
Serial Number
Purchase Date
-
Service Company and Telephone Number

For Best Results

Your dishwasher cleans by spraying a mix-
ture of hot, clean water and detergent against
soiled surfaces of dishes. When a cycle is started, the dishwasher fills with water to about
the level of the heating element. This water is
pumped through the rotating spray arms, drained through the filter system which re­moves food and soil, and pumped back
through the rotating spray arms. Soiled water
is pumped out and replaced with clean water during a cycle-the number of times depends on the cycle being used.
Load dishes so soiled surfaces face pow­erful spray from rotating arms.
T The self-cleaning
removable pump guard help ellmlnare pre­rinsing by removing food particles from the

The filtering system

It is not necessary to rinse dishes before
putting them into the dishwasher. Just remove
large pieces and quantities of food and bones. The filtering system helps keep food particles out of the wash water. Small particles are flushed away as water is pumped out. Larger particles are trapped in the pump guard.
To remove the pump guard for cleaning...
1. Wait at least 20 minutes after a cycle for the heating element to cool down.
2. Unload and remove the bottom rack.
Water must be hot
For best cleaning and drying results, water should be at least 140°F (60°C).
1. Turn on hot water faucet nearest the dishwasher. Let water run until it is as hot as possible.
2. Hold a candy or meatthermometer in the stream of hot water
to measure the temperature.
3. If the temperature is too low, have a qualified person raise
Check Water
Temperature
the water heater thermostat setting.
filtering system and
3. Press the outside wall of the pump guard at the center to release the latch.
4. Lift out and rinse clean.
To replace the pump guard...
1, Insert pump guard legs (on inside wall) into
matching openings in filter screen.
2. Press down on outside wall until latch snaps into place.
3. Replace bottom rack with rack bumpers in front.

Quiet operating tips

To avoid thumping and clattering noises during operation:
l
Make sure lightweight load items are secured in the rack.
l
Make sure pot lids and handles, pizza pans, cookie sheets, etc. do not touch interior walls
4
or interfere with either of the spray arms rotation.
l
Load dishes so they don’t touch one another.
NOTE: Keep sink drain plugs inserted durlng dtshwasher opemtlon to prevent noise
fer through dmlns.
tmns-

Proper loading

Always load dishes so soiled surfaces are reached by spray from rotating spray arms. Water must be able to drain off completely for best drying results. Be careful to separate items so spray can reach all surfaces.

Top rack loading

CUP AND GLASS LOAD
l
The top rack is designed for cups, glasses and smaller items.
l
Place so open ends face down for clean­ing and draining.
l
load glasses in top rack only. Bottom rack is not designed for glasses. Damage may occur.
Place items in the rows between prongs. Placing them over the prongs can lead
to breakage.
l
Be sure lightweight items are held firmly in place.
l
China, crystal and other delicate items must not touch each other during dish­washer operation. Damage may occur.
l
l
Load plastic items in the top rack only. Only plastic items marked “dishwasher
Small bowls, pans and other utensils can
be placed in the top rack.
safe” are recommended.
l
Plastic items can be melted in the bottom
rack.
l
Items with cooked-on or dried-on foods should be loaded in the bottom rack with soiled surfaces facing the spray.
Loading...
+ 11 hidden pages