BEFORE YOU USE YOUR DISHWASHER
IMPORTANT SAFETY INSTRUCTIONS
PARTS AND FEATURES 3
POWER CLEAN” WASHING SYSTEM 4
PROPER LOADING 5 ENERGY SAVING TIPS 10
Top Rack Loading 5 SPECIALTIPS
Bottom Rack Loading
Silverware Basket Loading
ADDING DISHWASHER DETERGENT
RINSE AID DISPENSER
BEFORE STARTING YOUR DISHWASHER 8 I, Before Calling for Assistance 15
STARTING YOUR DISHWASHER 8
Changing a Setting
To Add a Dash After Starting : 1 : :
Before you use your dishwasher
It Is your personal responsiblllty and obligatlon to be sure your dishwasher:
l
Is installed by a qualified installer.
l
Has been installed where it is protected from the elements.
l
Has been installed on a floor strong enough to support its weight.
l
Has been properly connected to electricity, water and drain.
l
Has been properly electrically grounded.
l
Is not used by children or anyone unable to operate it properly
0 Is properly maintained.
See installation instructions for complete information.
HI-TEMP WASHING Option 8
2
Selecting a Cycle 9
2
The AIR DRY Option
The RESET OPTIONS Button’ :
6 COMMON DISHWASHING PROBLEMS 12
6 CONNECTING YOUR PORTABLE
7
DISHWASHER 14
7 IF YOU NEED SERVICE OR ASSISTANCE 15
2. If You Need Assistance 15
3. If You Need Service 15
B
4. If You Have a Problem 15
B
Page
9
9
1 1
‘Tmk.
Parts and features
Models DU5000XL (shown)
and DP6880XL
UPPER SPRAY ARM
TOP RACK
(Adjustabl
DP6880XL
BOTTOM RACK
RACK BUMPER
DETERGENT DISPENSERS \
SILVERWARE BASKET -
HEATING ELEMENT
11;
LOWER SPRAY ARM
THE OVERFLOW
ROTECTOR is
esigned to prevent
)o much water
om entering the
ishwasher. It Is not
removable.
THE POWER CLEAN* MODULE is designed to
keep the wash and rinse water clean. It also
grinds up and removes food particles. During
grindlng, some sounds will be heard.
-Tmk.
Copy your Model and Serial Numbers here.. .
When you need service or call with a question,
have this information ready:
1. Complete Model and Serial Numbers (from the
plate located as shown).
2. Purchase date from sales slip.
Copy this information in these spaces. Keep this
book, your warranty and sales slip together in a
handy place.There is no warranty registration to
return. Proof-of-purchase is all that is required for
in-warranty service.
Model Number
Serial Number
Purchase Date
Service Company and Telephone Number
POWER CLEAN* Washing System
Your dishwasher cleans by spraying a mixture of hot, clean water and detergent
against soiled surfaces of dishes. When
to about the level of the heating element. This water is pumped through the rotating
spray arm&through the POWER CLEAN Module which removes food particles.and back
through the rotating spray arms. Soiled water is pumped out and replaced with clean
water during a cycle - the number of times depends on the cycle being used.
Load dishes so soiled surfaces face powerful spray from rotating arms.
a cycle
is
started,
The POWER CLEAN* Module removes food
particles from the water, stores them, then
washes them down the drain.
the dishwasher fills with water
Step-saving preparation for washing
It Is not necessary
to rinse dishes before
putflng them Into the
dishwasher. Just remove large pieces,
bones, and other hard
items. The POWER
CLEAN Module will
remove food parti-
Hot water is a must
Hot water dissolves
and activates the
dishwashing detergent. Hot water dlssolves grease on
dishes and helps dry
glasses spot-free.
Make certain loads
are washed in hot
water (at leas1140 F -
Check Water
Temperature
I. Maintain 14O’F water supply at central
water heater. To check water temperature,
60 C). Two ways to
have a reliable hot
water supply...
cles from the water. It contains a chopping device which will reduce the size of food items.
If hard items such as fruit seeds, nuts and
egg shells enter the POWER CLEAN Module,
you might hear chopping, grinding, crunching or buzzing sounds. Those sounds are normal when hard items enter the module. DO
NOT LET MEfAUlC ITEMS GET INTO THE POWER
CLEAN MODULE.
turn on hot water faucet nearest the dishwasher. Let water run until it is as hot as possible, then check with a candy or meat
thermometer. If the temperature is too low,
have a qualified person raise the water
heater thermostat setting.
2
Use HI-TEMP WASHING Option. If water heating is needed, a thermostat will delay the
cycle until temperature reaches 145-F
(63 C], If water is hot enough, the cycle will
proceed with no delay. This lets you turn
down your water heater, if you choose,
without cutting back on hot water needed
for good dishwashing.
-1mk
4
Proper loading
Always load dishes so soiled surfaces are reached by spray from rotating spray arms.
Water must be able to drain off complet$ly for best drying results. Be careful to
items so spray can reach all surfaces.
Top rack loading
CUP AND GLASS LOAD
I
Separate
The top rack is designed for cups, glasses
and smaller items.
l
Place so open ends face down for cleaning and draining.
l
load glasses In top rack only. Bottom
rack is not designed for glasses. Damage
may occur.
ADJUSTABLE TOP RACK
(Model DP6880XL Only)
The top rack does not have to be level.
7
LOWER
Raise or lower one or both sides to help
fit tall items in the top or bottom rack.
Turn knob clockwise to raise a side.
Turn knob counterclockwise to lower a side.
l
Place items in the rows between prongs.
Placing them over the prongs can lead
to breakage.
l
Be sure light items are held firmly in place.
l
China, crystal and other delicate items
must not touch another item during dishwasher operation. Damage may occur.
1
Load plastic items only In the top rack.
Only plastic items marked “dishwasher
safe” are recommended.
Plastic items can be melted in the bottom
rack.
Small bowls, pans and other utensils
can be placed in the top rack.
UTENSIL LOAD
l
Items with cooked-on or dried-on foods should be loaded in the bottom rack with
soiled surfaces facing the spray.
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.