Before using the dishwasher, read the user instructions!
CW 491
Indicators
Programmes Loading instructions A B
Quick Reference Guide
Programme selector knob
Mains
On / Off
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Programme chart
Wash cycle
Pre-Rinse Washing Drying
Options
3)
Time and failure display
Indicates in hours the time remaining until the
start of the wash cycle. Toward the end of the
programme, during the drying cycle, the display
will indicate the time remaining in minutes.
“F....” Identification of faults for service
technician
“Delayed start” button
The wash cycle can be programmed to start
after 1 - 24 hours. With each successive touch
of the button, the delayed start indicator
increases by 1 hour, and after 24 returns to 00.
Then press the Start button. The dishwasher
will start at the set time.
“Half load” button
The half load cycle can be used for the upper
and lower rack. Select the required
programme then press the “Half Load”
button. The light comes on and goes off at
the end of the programme.
The “Half Load” function can be used with
programmes marked with an *.
Detergent
2)
Litres kWh Minutes
Programme
Consumption
GB
end
3)
Pre-Rinse cold
Quickwash 40°C
1) (*)
Bio
Normal
(*)
Intensive 70°C
1) Reference programme for energy label in c ompliance with
EN 50242 regulations;
2) Refer to “User instructions”;
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
Crockery to be washed later. - - 5.0 0.02 10
Lightly soiled crockery with no dried-
on food.
Normally soiled crockery. X X 16.0 1.24 133
50°C
Normally or heavily soiled crockery. X X 16.0 1.35 120
60°C
Recommended programme for heavily
soiled crockery, especially suitable for
pans and saucepans.
3) The data relevant to programmes are values obtained in the
laboratory in conformity with Standard EN 50242. In practical
use there may be time variations or leaps depending on
different loads, function options, water temperatures or
hardness and different power supply voltages.
X - 13.0 0.70 30
X X 17.0 1.65 145
5019 696 93215
(We reserve the right to make technical modifications)
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Switch on the appliance
How to fill the
detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the racks
Close the dishwasher door,
turn on the water tap
Select a programme
Automatic start by turning the programme selector knob (in case of
retractable knob, first press the knob to access it).
Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash
only.
If using combined action dishwasher
tabs, follow the user instructions!
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator D. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
Select the desired programme.
The corresponding indicator lamp comes on.
A:
B:
ABC
Select options
Press the Start button
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is
then memorised (even in the
event of power failure).
Only after the START button has switched off: Access the knob (in case of
retractable knob, press and then release the knob).
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme in progress”
Press the ST ART button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.