Whirlpool GKB 3400, AFG 387/G, FRUL 2904, FRUL 2004, CVT 4330/1 Product sheet
...
6gb33007.fm5 Page 1 Monday, February 12, 2001 3:56 PM
PRODUCT SHEET
1.
Compartment for freezing
2.
Control unit
3.
Area for drawers and pull out baskets/doors
4.
Pull-out defrost water drain
5.
Rating plate (on the inside of the appliance)
6.
Ice packs (inside) if provided.
storage compartment
freezer compartment
Note: the design of drawers and accessories may vary, depending on the model.
Controls
(depending on model)
GB
A
Thermostat knob.
B
Yellow LED: indicates that the fast freeze
function is in operation.
C
Red LED: indicates that the freezer internal
temperature is too high.
5019 603 33007
D F NL E P GR
GB
D
Green LED: indicates that the appliance is
connected to the power supply.
E
Fast freeze button.
F
Electronic thermometer
I
S N FIN
DK
6gb33007.fm5 Page 2 Monday, February 12, 2001 3:56 PM
Freezer compartment temperature adjustment
The appliance is normally factory set for optimum operation at a temperature of -18°C.
To adjust the compartment temperature, proceed as follows:
•
Turn the thermostat knob A to
•
Turn the thermostat knob A to
•
Turn the thermostat knob A to z to switch off the freezer (the appliance is still connected to the
mains power supply).
Model with electronic thermometer
•
The LED indicates the highest temperature reached inside the appliance. For optimum food
storage, set the thermostat at a temperature of -18°C. The introduction of large amounts of food
and frequent opening of the door can temporarily affect the internal temperature of the appliance.
•
To deactivate the fast freeze function, press the button
manually deactivated, after approx. 48 hours the appliance will automatically deactivate it.
•
When the appliance is switched on, all the LEDs light up in sequence for a few seconds, after
which the appliance begins operation.
1/Min
for a storage temperature that is less cold.
7/Max
for a colder storage temperature.
(E)
; if the fast freeze function is not
Alarm signals
Temperature alarm
Electronic thermostat
fault alarm (for models
with electronic
thermostat)
Signal Cause Solution
The red LED lights up
The green LED
yellow LED
and blink
B
D
and the
light up
C
The internal
temperature is above
-12°C
Electronic card fault Contact After-sales
Press button E until the
temperature returns
below -12°C again
service. The appliance
still operates,
guaranteeing correct
storage of food
5019 603 33007
D F NL E P GR
GB
I
S N FIN
DK
Printed in Italy 02/01
Loading...