Whirlpool C 313 BR, C 313 BL INSTRUCTION FOR USE
GB
C 313
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Programme selector
Start button
Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Power supply indicator lamp
Programme Symbol
and Temperature
Rapid 40° C
Eco 50° C
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water temperatures (above or below 15°C),
water hardness and power supply voltage, etc.
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.
2)
Lightly soiled crockery with no dried-on food.
Normally or heavily soiled crockery with dried-on food .
Heavily soiled pans and saucepans.
Programme selection and
recommended load type
Place the detergent in the:
small large
compartment compartment
- X 13.0 0.85 30
X X 16.0 1.24 133
X X 21.0 1.90 110
Water
(Litres)
Consumption
Normal load
Energy
(kWh)
5019 100 92234
(We reserve the right to make technical modifications)
1)
Time
(Min.)
C
D
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the programme
selector knob is turned.
supply indicator lamp switches on.
3. Turn the selector knob to select the
desired programme. If requ ired, s elect
options (if supplied).
4. Press the Start button to start the
selected programme. Once set, the
programmed data cannot be altered by
turning the programme selector knob.
once the Start button has been
Note:
pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start button
for about 5 seconds,
Start indicator lamp switches
Select a new programme and
off.
press the Start button.
if the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and the
lights up
End indicator lamp (if fitted)
(for about 30 min.)
The power
until the
.
6. Once the Start indicator lamp has
switched off, turn the programme
selector knob to the initial position to
switch off the dishwasher.
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
All the
Upper rack
Rack height adjustment:
(The dishwasher is delivered with the
upper rack in the top position).
The rack height can also be changed
when loaded.
• To lower: pull out the
handles and gently lower the rack.
two
side
Upper and lower rack
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both
sides.
Crockery holders:
• Down: cups and long-stemmed
glasses.
• Up: plates.
Glass holder:
side handles
two
Lower rack
C
Cutlery basket:
• The cutlery basket (C) can be
removed to increase available space.
• Some models are provided with a
grid (D) that can be fitted onto the
cutlery basket.
Please read the user instructions carefully.
Loading...