Whirlpool C 310 BL, C 310 BR INSTRUCTION FOR USE

GB

C 310

Quick Reference Guide

Further indications are given in the pages to follow and in the user instructions.

Programme selector

Start button

Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the pr ogramme.

Power supply indicator lamp

Programme Symbol

and Temperature

Pre-wash

Eco 50° C

Normal 65° C

1) Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C -, as well as water hardness and power supply voltage etc.

2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.

3) Programme recommended when using detergents of type A (non enzyme-based detergents).

2)

Crockery to be washed later.

Normally or heavily soiled crockery with dried-on food.

3)

Normally or heavily soiled crockery.

Programme selection and

recommended load type

small compartment large compartment

Place the detergent in the:

--8.00.0212

X X 19.0 1.40 87

X X 25.0 1.70 94

(We reserve the right to make technical modifications)

1)

Time

(Min.)

Water

(Litres)

Consumption

Normal load

Energy

(kWh)

5019 100 92201

C

C

How to use the dishwasher

1. After loading the dishwasher, cl ose the
door properly and open the water
supply tap.

2. The dishwasher switches on
automatically as soon as the programme
selector knob is turned.

supply indicator lamp switches on.

3. Turn the selector knob to select the
desired programme. If required, select
options (if supplied).

4. Press the Start button to start the
selected wash programme. Once set,
the programmed data cannot be
altered by turning the programme
selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.

To change the selected
programme, press the Start
button for about 5 seconds,

the Start indicator lamp
switches off.

programme using the
programme selector knob and
press the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.

Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from

5. To indicate the end of the programme,

steam.

the Start indicator lamp switches off
and

the End indicator lamp (if fitted)

lights up

(for about 30 min.)

The power

until

Select a new

.

6. Turn the programme selector knob to
the initial position to switch off the
dishwasher (only after the Start
indicator lamp has switched off).

the indicator lamps switch off.

7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.

• To lower: pull out the

All

• To raise: pull up the

• The rack must be level on both

Crockery holders:

• Down: cups and long-stemmed

•

Upper and lower rack

side

handles and gently lower the rack.

handles until the rack clicks into
place.

sides.

glasses.
Up: plates.

two

two

side

Lower rack

Cutlery basket:

• With or without handle (depending
on model).

• The cutlery basket can be removed
to increase available space.

Please read the user instructions carefully.