Whirlpool AWV 910 INSTRUCTION FOR USE
GB AWV 910
A. Programme Selection Knob
B. Temperature Selection Knob
C. “Spin Speed Selection” Knob
D. “On/Off” Button
i : option / Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted
to 900 rpm in this programme.
3)
For improved garment care, spin speed is null
A DCB
Max.
Programme
Cotton with prewash Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. 4,5 Yes 1)Yes
Synthetics with
prewash
Delicate with prewash Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5 Yes 1)Yes
Cotton Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. 4,5 – Yes
Care
Labels
Type of wash / Notes
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen,Trevira), polyamide (Perlon, Nylon) or
blends with cotton.
Load
kg
2,0 Yes 1)Yes
in this programme.
Detergents and Additives
Pre-
Main
wash
wash
“Cold“
Softener Bleach Half
i i i
i
i
i i i
–
– – Max. 40 900
Option
Load
i
Tempera-
ture
°C
Max. 95 950
Max. 60 900
Max. 95 950
Max.
Spin
Speed
rpm
2)
2)
Cotton short Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. 3,0 – Yes
Mixed Cotton/Synthet.
Synthetics Normally soiled overalls ans sportswear made of cotton, polyester, polyamide and blends with cotton. 1,5 – Yes
Delicate Curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5 – Yes
Wool Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. 1,0 – Yes
Silk Textiles made of silk, linen, wool and viscose marked as “handwashable”. 1,0 – Yes
Rinse + Gentle
Spin
Rinse + Spin – Programme for treating cotton or linen laundry with starch or softener. 4,5 – –
Spin – Programme to spin cotton or linen laundry intensively with maximum spin speed. 4,5 – – – – – – 950
Gentle Spin – Programme to spin delicate laundry gently with a restricted spin speed. 2,0 – – – – – – 900
Drain – Drain only - no spinning. – – – – – – – –
Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
– Programme for treating delicate laundry with starch or softener. 2,0 – –
2,0 – Yes
i
i
i
i
i
i
i
i
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
–
–
–
– – Max. 40 900
– – Max. 40 900
– – Max. 30 –
–
–
Ignis is a registered trademark of Whirlpool USA.
i
i
i
i
i
Max. 60 950
Max. 60 900
Max. 60 900
5019 512 10049
– 900
– 950
2)
2)
2)
2)
3)
2)
2)
CONSUMPTION DATA
Programme
Temperature
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 95 4,5 63* 1,80 2:05
Cotton 60 4,5 55 0,95 2:05
Cotton 40 4,5 55 0,55 2:05
Mixed Cotton/Synthetic 60 2,0 56 0,80 1:30
Synthetic 40 2,0 56 0,40 1:05
Delicate 40 1,5 60 0,55 0:45
Wool 40 1,0 60 0,50 0:40
Silk 30 1,0 60 0,30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values
in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the
dispenser to no more then the “MAX” level
mark, as follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.
“Half Load” button
• Reduces the water consuption in the “Cotton”
and “Synthetics” programmes especially during
the rinse.
• Especially suitable for lightly soiled or small
loads (reduces the quantity of detergent).
• Not suitable for high temperature programmes.
• Anti-scale agents (if necessary)
3. Turn the programme selector knob to the
desired programme.
4. Turn the temperature selector knob to the
desired temperature.
5. Turn the spin speed selector knob to the
desired spin speed. If the spin speed “ ” is
selected, the final spin is cancelled, but not the
intermediate spins. The programme ends with
a drain cycle.
PROGRAMME START
Turn on the tap and press the “On/Off” button .
The indicator light of the “On/Off” button lights
up.
Note: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop
position.
1. Press the “On/Off” button to switch off
the machine.
2. Cancel the option.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drum doors and unload
the machine.
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
1. Switch off machine by pressing the “On/Off”
button .
2. Select the new programme.
3. Start programme by pressing the “On/Off”
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the “On/Off” button .
2. After the desired pause, press again the
“ON/Off” button .
CANCEL PROGRAMME
1. Switch off the machine by pressing the
“On/Off” button .
2. Set the programme selector to “Drain” .
3. Press the “On/Off” button again to start
the “Drain” programme .
Ignis is a registered trademark of Whirlpool USA.
5019 512 10049
Loading...