Whirlpool AWV 404/3 INSTRUCTION FOR USE

AWV 404/3

“On/Off”

Programme duration figures (guideline) are valid for maximum temperature wash with no special functions

❉

: option / Yes: dosing required

Do not use liquid detergents.

Programme Type of wash / Notes

Cotton with

Prewash

Cotton

Coloured

Synthetics

Rinse + Spin

Spin Programme for intensive spin cycle.

Delicate Delicate fabrics and curtains (dresses, skirts, shirts, blouses, etc.).

Wool Machine washable woollens with pure new wool label.

Rinse + Spin

Spin

Drain

Heavily soiled sheets, tablecloths, underclothes, shirts etc. in hard wearing and high temperature resistant cotton.

The maximum load for heavily soiled washing is 3.5 kg.

Moderately soiled sheets, tablecloths, underclothes, towels etc. in hard wearing and high temperature resistant cotton.

Averagely soiled blouses, shirts etc. made of polyester (Diolen, Trevira); polyamide (Perlon, Nylon), or cotton blends.

Lightly soiled shirts, blouses etc., made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or cotton blends.

This programme allows starch or softener to be added. It is followed by an intensive spin cycle.

This programme allows starch or softener to be added. It is followed by a gentle spin cycle.

Programme for gentle spin cycle. Drain only, without spin cycle.

Alternative way to end programmes after a “Rinse Hold”.

Max.

load

5.0 Yes

5.0

2.0

5.0

1.5

1.0

1.5

Pre-

wash

—

——

Detergents and additives Options Temperature°CMaximum

Main

Wash

Yes

Yes Yes

Softener Bleach Cold Wash Half Load

❉❉❉ ❉

❉❉❉ ❉ ❉ ❉

—

———— —

❉

❉ ❉

—

———— — —

———— — — —

❉

—

——

—

—— —

❉❉ ❉❉

❉

❉ ❉

—

90 400 130

90 400 115

60 400 100

40 400 70

Cold 400 20

— 400 15 40 400 55 30 400 45

Cold 400 15

Spin

Speed

rpm

400 10

Programme

time

approx.

min

N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.

Ignis is a registered trademark of Whirlpool USA.

5019 512 10031

ENERGY AND WATER CONSUMPTION DATA

Programme Temperature

Load

Water

Energy

Programme time

(°C)

(kg)

(l)

(kWh)

(min)

Cotton 90 5.0 72 1.80 115 Cotton 60 5.0 69 0.95 115

Coloured 60 2.0 66 0.80 100

Synthetics + 1/2 Load 40 1.0 54 0.40 70

Delicate 40 1.5 70 0.65 55

Wool 40 1.0 70 0.55 45

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household

conditions applicable at that time.

**T o reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the

water out.

PREPARATION OF WASH CYCLE PRESS ANY DESIRED OPTION BUTTON(S)

1. Close the drum flaps and check that they are properly locked.

2. Add detergents and additives into the dispenser to no more then the

“MAX”

level mark, as

follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the

programme selector knob

clockwise

to the desired programme.

“Cold Wash” button

• This option suppresses the heating of the water.

• You can use this option with all washing cycles.

“Half Load” button

• Reduces the water consumption in the “Cotton” and “Synthetics” programmes especially during the rinse.

• Especially suitable for lightly soiled or small loads (reduces the quantity of detergent).

• Not suitable for high temperature programmes.

PROGRAMME START

Open the water inlet tap and press the

“On/Off”

button. The pilot lamp lights up.

DOOR LOCK

During the running programme, the door cannot be opened. The door locks automatically in all programmes. If the programme is stopped or if an electrical power failure occurs, the door unlocks automatically after about 1 minute.

PROGRAMME END

• The programme selector knob is at “STOP”, the pilot lamp lights.

1. Press the

“On/Off”

button. The pilot light goes

out.

2. Cancel the options by pressing the appropriate buttons.

3. Turn the water supply tap off.

4. Wait for the door to unlock (about 1 minute).

5. Open the door and the drum flaps and unload the machine.

SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME START

1. Press the

“On/Off”

button to switch off the appliance. The pilot light goes out.

2. Select the new programme and options.

3. Press the

“On/Off”

button to switch on the appliance. The pilot light lights.

TO STOP, RESET A PROGRAMME BEFORE THE END

1. Press the

“On/Off”

button to switch off the appliance. The pilot light goes out.

2. Set the programme selector on “Drain”.

3. Press the

“On/Off”

button to start the “Drain” programme. Only open the door when the programme selector is at “STOP” and the door is unlocked (after approximately 1 minute).

NOTES AND INDICATIONS FOR USE

• After switching your washing machine on, it does not start immediately: it needs some seconds in order to lock the door, fill water and then drum starts turning.

• Spinning has an interrupted start-up: the drum starts and stops running several times, to improve spin efficiency and to better balance the laundry.

• At the end of the spinning cycle the drum goes on reversing for some minutes: this helps you unloading the laundry.

• Do not exceed in detergents dosage: excessive foam formation may prevent spinning.

• The turning of the drum is stopped in several steps of the washing cycle due to optimization of energy consumption.

Ignis is a registered trademark of Whirlpool USA.

5019 512 10031