Whirlpool AWT 6064 Quick Reference Guide

GB
Delicate 40° with
AWT 6064
Programme
Cotton 90°
with prewash
Synthetic 60°
with prewash
prewash
Cotton
40°-60°-90°
Synthetic
60°-40°
Delicate 40°
Wool 40°
Silk 30°
Rinse + Spin
Rinse +
Intensive Spin
Intensive Spin
Spin
Drain
Prelavaggio Cotone
90°
Prelavaggio Sintetici
60°
Prelavaggio Delicati
40°
Cotone
40°-60°-90°
Sintetici
60°-40°
Delicati 40°
Lana 40°
Seta 30°
Risciacquo e
Centrifuga
Risciacquo e
Centrifuga Intensiva
Centrifuga
Intensiva
Centrifuga
Scarico acqua
Care
Labels
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as
machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Same as the last two rinses and the final spin in the “Synthetic” programme.
Programme for treating wash with starch or softener. Same as the last rinse and the final spin in the “Cotton” programme.
Programme for treating wash with starch or softener. In this programme spinning is intensive. Same as the spin cycle in the “Cotton”
programme. In this programme spinning is gentle. Same as the spin cycle in the “Wool”
programme. Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
N.B. Please avoid excessive detergent dosing.
A. “Start” Button B. “Temperature” Indication lamps C. “Spin Speed Selection” Button
ABC
Max. load
Type of wash / Notes
kg
5.0
2.0
1.5
5.0
2.0
1.5
1.0
1.0
2.0
5.0
5.0
2.0
—————
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted to 500 rpm in this programme.
3)
For improved garment care, spin speed is zero in this programme.
Detergents and additives Special Options Max.
Prewash Main
Yes
Yes
Yes
Wash
1)
1)
1)
— —
——
——
————
————
Softener Bleach Cold Wash Half Load Intensive
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Lavaggio
Freddo
❉❉❉❉❉❉ ❉ ❉
❉❉❉❉ ❉
❉❉❉❉❉❉
❉ ❉
❉ ❉
❉ ❉
— —
❉❉❉❉ ❉
❉ ❉
❉ ❉
Mezzo Carico
❉ ❉
Whirlpool is a registered trademark of Whirlpool USA.
Rinse
Risciacquo
Intensivo
Anti Piega
——
——
——
——
——
——
———
——— ————
5019 312 00041
Rinse
Hold
❉ ❉
❉ ❉ ❉
Spin
Speed
rpm
600
500
500
600
500
500
500
0
500
600
600
500
2)
2)
2)
2)
2)
3)
2)
2)
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes) Cotton 90 5.0 *63 1.80 2:05 Cotton 60 5.0 55 0.95 2:05 Cotton 40 5.0 55 0.55 2:05
Synthetic 60 2.0 56 0.80 1:35 Synthetic 40 2.0 50 0.40 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the Energy Label refer to the programme Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE
1. Load the machine, close the drum flaps and check that they are properly locked.
2. Add detergents and additives into the dispenser to no more then the
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3. Press the
On/Off
and, in case of availability, a temperature indicator lamp light up.
4. Turn the programme selector knob to the desired programme and temperature.
half a step for correct positioning. The temperature indication (if available) switches to the selected temperature.
On/Off
button, a spin speed indicator lamp
MAX
level mark, as follows:
button. The pilot lamp of the
The knob will move
Cold Wash button
Can be used with all washing programmes.
Suppresses heating of the water.
Half Load button
Can be used for small loads and lightly soiled laundry.
Reduces the water consumption especially during
the rinses.
Intensive Rinse button
One rinse cycle is added to ensure a more intensive rinse.
This option is particularly suitable for areas with very soft water, washing baby linen and people with detergents allergies.
SELECT THE DESIRED OPTION
Rinse Hold button
The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.
This option is particularly recommended for the Synthetic or Delicate programmes.
This function is particularly useful if you want to
postpone spinning to a later time, or if you want to drain only.
Note:
The programme selector knob stops on the
position
Appliance in Rinse Hold”:
Press the Rinse Hold button again: the programme will terminate automatically with the selected spin cycle.
If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the
Spin Speed Selection button
The appliance selects the spin speed proposed for the programme choosen.
Press the button to set another spin speed.
If the spin speed 0 is selected, the final spin is
cancelled, but not the intermediate spins. The programme ends with a drain cycle.
.
Start
button again.
PROGRAMME START
Start
button lights up.
Start
button. The
Turn on the tap and press the indicator lamp of the
Note
: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.
END OF WASH CYCLE
The programme selector knob is in the Stop
position “O”.
1. Press the
machine.
2. Turn the tap off.
3. Wait for the door to unlock (about 1 minute).
4. Open the door and the drum flaps and unload
the machine.
On/Off
button to switch off the
CHANGE THE PROGRAMME DURING THE WASH CYCLE
1. Turn the programme selector knob to the new
programme.
moves half a step and the pilot lamp of the Start button flashes.
additional options and the spin speed.
2. Start programme by pressing the
button.
The programme selector knob
If necessary, select the
Start
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the programme for a certain time and continue it later:
1. Press the
2.
After the desired pause, press again on the
On/Off
On/Off
button.
button.
CANCEL PROGRAMME
1. Set the programme selector to “Drain”.
2. Press the
programme.
Start
button to start the “Drain”
Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 00041
Loading...