Whirlpool AWT 5099 INSTRUCTION FOR USE

AWT 5099

BCA D

A. Temperature Selection Knob B. “Programme Sequence” Indication C. “On/Off” Button D. “Spin Speed Selection” Knob

“Cold”

❉

: option / Yes: dosing required

Do not use liquid detergents.

For improved garment care, spin speed is restricted to 600 rpm in this programme.

For improved garment care, spin speed is zero in this programme.

Programme

Cotton with

prewash

Synthetic with

prewash

Delicate with

prewash

Cotton

Coloured

Daily Slightly to normally soiled textiles made of cotton and/or synthetics

Mixed

Synthetic

Delicate Curtains and delicate clothing, dresses, skirts, shirts and blouses.

Wool

Silk

Rinse +

Gentle Spin

Rinse + Spin

Spin —

Gentle spin —

Drain —

Care

Labels

—

Type of wash / Notes

Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,

Nylon) or blends with cotton. Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.

Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton

and linen.

Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.

Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.

If you select “Rinse Hold” do not leave items to soak for too long.

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

If you select “Rinse Hold” do not leave items to soak for too long. No spinning.

Same as the last two rinses and the final spin in the “Synthetic” programme. P

treating wash with starch or softener. Same as the last rinse and the final spin in the “Cotton” programme. Programme for treating wash with starch or softener.

In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.

In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.

Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.

N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.

rogramme for

Max. load

5.0

2.0

1.5

5.0

3.0

2.0

1.5

1.0

2.0

5.0

2.0

Detergents and additives Options Temperature

Prewash Main

Yes

— — — —

— —

—

——

Softener Bleach Rapid Eco

Wash

Yes

❉❉❉❉❉❉ ❉

—

❉

——— —

❉❉❉❉❉❉ ❉

———

❉

———

❉

—

❉

———

❉

——— —

❉

——— —

❉

——— —

❉

——— —

❉

——— —

Wash

Intensive

Rinse

Hold

❉❉ ❉ ❉

❉

❉❉ ❉❉

❉❉ ❉ ❉

❉❉

❉ ❉

❉ ❉ ❉

Selector

°C

Max. 90 900

Max. 60

Max. 40

Max. 90 900

Max. 60 900

Max. 60

Max. 40

Max. 30

—

——————— — — ——————— — —

Maximum

Spin

Speed

rpm

600

—

600

900

600

————————— — —

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 10129

CONSUMPTION DATA

Programme

Temperature Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes) Cotton 90 5.0 63* 1.80 2:05 Cotton 60 5.0 55 0.95 2:05 Cotton 40 5.0 55 0.60 2:05

Daily Mixed 40 3.0 45 0.48 1:00

Mixed 60 2.0 62 0.80 1:35

Synthetic 40 2.0 56 0.45 1:30

Delicate 40 1.5 63 0.45 0:50

Wool 40 1.0 63 0.45 0:40

Silk 30 1.0 63 0.30 0:50

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to the programme “Cotton 60° C”.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the

water out.

PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION

1. Load the machine, close the drum flaps and check that they are properly locked.

2. Add detergents and additives into the dispenser to no more then the

“MAX

” level mark, as

follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the

programme selector knob

to the

desired programme.

4. Turn the

temperature selector knob

to the

desired temperature.

5. Turn the

spin speed selector knob

to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle.

Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.

“Rapid Wash” button

• For quick, economical washes.

• Ideal for minimum loads of lightly-soiled articles.

Note:

reduce the detergent quantity.

“Eco Wash” button

• The wash time is extended and the water temperature is reduced.

• This function saves about 30% in energy without compromising the excellent results of the wash.

“Intensive Rinse” button

• One rinse cycle is added to ensure a more intensive rinse.

• This option is particularly suitable for areas with very soft water, washing baby linen and people with detergents allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.

• This option is particularly recommended for the “Synthetic” or “Delicate” programmes.

• This function is particularly useful if you want

to postpone spinning to a later time, or if you want to drain only.

Remark:

the programme selector knob stop on “”.

Appliance in “Rinse Hold”:

• Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle.

• If you do not wish to spin the clothes, press the

On/Off

“

” button , turn the programme

selector knob to the “Drain” programme and press the “

On/Off

” button again.

PROGRAMME START

Turn on the tap and press the “ The indicator light of the “

On/Off

” button .

” button

lights up.

Note

: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.

END OF WASH CYCLE

• The programme selector knob is at “STOP”, the

pilot lamp lights.

1. Press the “

On/Off

” button to switch off the

machine.

2. Cancel the options.

3. Turn the tap off.

4. Wait for the door to unlock (about 1 minute).

Open the door and the drum flaps and unload

the machine.

CHANGE THE PROGRAMME DURING THE WASH CYCLE

1. Switch off the machine by pressing the

On/Off

“

” button .

2. Select the new programme. Start programme by pressing the “

On/Off

”

button again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the programme for a certain time and continue it later:

1. Press the “

On/Off

” button .

2. After the desired pause, press again the

“On/Off”

button .

CANCEL PROGRAMME

1. Switch off the machine by pressing the

On/Off

“

” button .

2. Set the programme selector to “Drain” .

3. Press the “

On/Off

” button again to start

the “Drain” programme .

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 10129