Whirlpool AWT 5088/3 INSTRUCTION FOR USE
GB
AWT 5088/3
A. Programme Selection Knob
B. Temperature Selection Knob
C. “Spin Speed Selection” Knob
D. “On/Off” Button
B CA D
Programme
Cotton with prewash
Synthetic with prewash
Delicate with prewash
Cotton
Coloured Cotton Normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and linen.
Daily Mixed Slightly to normally soiled textiles made of cotton and/or synthetics.
Synthetic
Synthetic short Normally soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.
Delicate Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Wool
Handwash
Rinse + Gentle Spin
Rinse + Spin
Spin
Gentle spin
Drain
Care
Labels
—
—
—
—
—
Type of wash / Notes
Heavily soiled bed linen, table linen and underwear , towels, shirts etc. made of cotton an d linen.
Heavily soiled blouses, shirts, overalls et c. m ade o f polyester (Diolen, T r evira), polyamid e (P erlon, Nylon)
or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally to heavily soiled bed linen, table linen an d und erwear, towels, shirts etc. made of cotton and linen.
Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long.
Programme for treating delicate laundry with starch or softener.
Programme for treating cotton or linen laundry with starch or softener.
Programme to spin cotton or linen laundry intensively with maximum spin speed.
Programme to spin delicate laundry gently with a restricted spin speed.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
Cold
❉
: option / Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care spin speed is null in this
programme.
Max.
load
kg
5.0
2.0
1.5
5.0
3.0
3.0
2.0
1.5
1.5
1.0
1.0
2.0
5.0
5.0
2.0
Detergents and additives Special Options Tempera-
Prewash Main
1)
Yes
1)
Yes
1)
Yes
—
—
—
—
—
—
—
—
——
——
Softener Bleach Rapid Intensive
Wash
Yes
❉❉❉❉❉
Yes
❉
—
Yes
❉
—— —
Yes
❉❉❉❉❉
Yes
❉
——
Yes
❉
——
Yes
❉
—
Yes
❉
——
Yes
❉
—— —
Yes
❉
—— —
Yes
❉
—— —
❉
—— —
❉
—— —
Rinse
❉❉❉
❉❉
❉❉
❉❉❉
❉❉
——————— —
——————— —
Rinse
Hold
❉
❉
❉
❉
❉
❉
ture
°C
Max. 95
Max. 60
Max. 40
Max. 95
Max. 60
Max. 60
Max. 60
Max. 60
Max. 40
Max. 40
Max. 30
—
—
Max.
Spin
Speed
rpm
800
800
800
800
800
800
800
800
800
800
—
800
800
800
800
2)
—————— —— — —
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10072
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 95 5.0 63* 1.80 2:05
Cotton 60 5.0 55 0.95 1:55
Cotton 40 5.0 55 0.60 1:55
Daily Mixed 40 3.0 45 0.48 1:00
Synthetic 60 2.0 62 0.80 1:35
Synthetic 40 2.0 56 0.45 1:30
Delicate 40 1.5 63 0.45 0:50
Wool 40 1.0 63 0.45 0:40
Handwash 40 1.0 63 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To r ed u ce th e w ater temperatur e, some cold water is added at the end of th e m ain w ash cycle, before the pump drains the
water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
“MAX”
level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
desired temperature.
5. Turn the
spin speed selector knob
to the
desired spin speed. If the spin speed “0” is
selected, the final spin is cancelled, but not the
intermediate spins. The programme ends with a
drain cycle.
Selecting or deselecting an option can be done at
any time during the programme. The option will
be applied as long as the corresponding
programme phase has not been executed yet.
“Rapid” button
• For fast, energy saving wash cycles.
• Ideally suited for sm all loads con sisting of lightly
soiled laundry.
“Intensive Rinse” button
• One rinse cycle is added to ensure a more
intensive rinse.
• This option is particularly suitable for areas with
very soft water, washing baby linen and people
with detergents allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic”, “Delicate” and “Daily Mixed”
programmes.
• This function is particularly useful if you want
to postpone spinning to a later time, or if you
want to drain only.
Note:
the programm e selector kn ob stops on .
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
programme will terminate automatically with
the selected spin cycle.
• If you do not wish to spin th e clothes, pr ess the
On/Off
“
” button, turn the programme selector
knob to the “Drain” programme and press the
On/Off
“
” button again.
PROGRAMME START
Turn on the tap and press the “
The indicator light of the “
On/Off
On/Off
” button.
” button lights
up.
Note
: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop
position.
1. Press the “
On/Off
” button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
Open the lid and the drum doors and unload
5.
the machine.
CHANGE THE PROGRAMME DURING THE WASH
CYCLE
1. Switch off the machine by pressing the
On/Off
“
” button.
2. Select the new programme.
Start programme by pressing the “
3.
On/Off
”
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the “
On/Off
” button.
2. After the desired pause, press again the
“On/Off”
button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
On/Off
“
” button.
2. Set the programme selector to “Drain”.
3. Press the “
On/Off
” button again to start the
“Drain” programme.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10072
Loading...