Whirlpool AWT 5080 INSTRUCTION FOR USE

GB AWT 5080

A. Programme Selection Knob B. Temperature Selection Knob

“Cold“

C. “Spin Speed Selection” Knob D. “On/Off” Button

i : option / Yes: dosing required

Do not use liquid detergents.

For improved garment care, spin speed is restricted

to 700 rpm in this programme.

For improved garment care, spin speed is null

A DCB

Max.

Programme

Cotton with prewash Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. 5,0 Yes 1)Yes

Synthetic with

prewash

Delicate with prewash Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5 Yes 1)Yes

Cotton

Coloured cotton

Daily Mixed Slightly to normally soiled textiles made of cotton and/or synthetic. 3,0 – Yes

Mixed Cotton /

Synthetic

Delicate Curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5 – Yes

Wool

Handwash

Rinse + Gentle

Spin

Rinse + Spin – Programme for treating cotton or linen laundry with starch or softener. 5,0 – –

Spin – Programme to spin cotton or linen laundry intensively with maximum spin speed. 5,0 – – – – – – – – – 800

Gentle Spin – Programme to spin delicate laundry gently with a restricted spin speed. 2,0 – – – – – – – – – 700

Drain – Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”. – – – – – – – – – – –

Care

Labels

Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen,Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Normally soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.

Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.

If you select “Rinse Hold” do not leave items to soak for too long.

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

If you select “Rinse Hold” do not leave items to soak for too long. No spinning.

– Programme for treating delicate laundry with starch or softener. 2,0 – –

Type of wash / Notes

Load

2,0 Yes 1)Yes

5,0 – Yes

3,0 – Yes

2,0 – Yes

1,5 – Yes

1,0 – Yes

Detergents and Additives Special options Tempera-

Pre-

Main

wash

Softener Bleach Rapid Half

wash

in this programme.

Intensive

Load

i i

i i i i i i

–

i i i

– –

– – – –

–

– –

–

– – – –

– –

i i i

i i i i

i i i

i i i i

i i

Rinse

Hold

Max. 95 800

Max. 60 700

Max. 40 700

Max. 95 800

Max. 60 800

Max. 60 700

Max. 40 700

Max. 30 –

ture

°C

Max. Spin

Speed

rpm

– 700

– 800

N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 10394

CONSUMPTION DATA

Temperature

Programme

Cotton 95 5,0 63* 1,80 2:05 Cotton 60 5,0 55 0,95 2:05 Cotton 40 5,0 55 0,55 2:05

Daily Mixed 40 3,0 49 0,48 1:00

Synthetic 60 2,0 56 0,80 1:30 Synthetic 40 2,0 56 0,40 1:30

Delicate 40 1,5 60 0,55 0:45

Wool 40 1,0 60 0,50 0:40

Handwash 30 1,0 60 0,30 0:50

Prewash cycle increases programme duration by approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to programme “Cotton 60°C”.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)

PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION

1. Load the machine, close the drum doors and check that they are properly locked.

2. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the programme selector knob to the desired programme.

4. Turn the temperature selector knob to the desired temperature.

5. Turn the spin speed selector knob to the desired spin speed. If the spin speed “ ” is selected, the final spin is cancelled and the programme ends with a drain cycle.

Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.

“Rapid” button

• For fast, energy saving wash cycle.

• Ideally suited for small loads consisting of lightly

soiled laundry.

“Half Load” button

• Can be used for small loads and lightly soiled

laundry.

• Reduces the water consumption especially during the rinse.

“Intensive Rinse” button

• The amount of water is increased to ensure a

more intensive rinse.

• This option is particulary suitable for areas with very soft water, washing baby linen and people with detergents allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water

without progressing to the final spin cycle to avoid creasing and prevent colours from fading.

• This option is particularly recommended for the “Synthetic” , “Delicate” and “Daily Mixed” programmes.

• This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.

Note: The programme selector knob stops on . Appliance in “Rinse Hold” :

• Press the “Rinse Hold” button again: the

programme will terminate automatically with the selected spin cycle.

• If you do not wish to spin the clothes, press the “On/Off” button , turn the programme selector knob to the “Drain” programme and press the “On/Off” button again.

PROGRAMME START

Turn on the tap and press the “On/Off” button . The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.

END OF WASH CYCLE

• The programme selector knob is in the Stop

position.

1. Press the “On/Off” button to switch off the machine.

2. Cancel the option.

3. Turn the tap off.

4. Wait for the lid to unlock (about 1 minute).

5. Open the lid and the drum doors and unload the machine.

CHANGE THE PROGRAMME DURING THE WASH CYCLE

1. Switch off machine by pressing the “On/Off” button .

2. Select the new programme.

3. Start programme by pressing the “On/Off” button again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the programme for a certain time and continue it later:

1. Press the “On/Off” button .

2. After the desired pause, press again the “On/Off” button .

CANCEL PROGRAMME

1. Switch off the machine by pressing the “On/Off” button .

2. Set the programme selector to “Drain”.

3. Press the “On/Off” button again to start the “Drain” programme .

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 10394