Whirlpool AWT 4090 INSTRUCTION FOR USE

GB AWT 4090

Programme

Cotton with prewash

Synthetics with

prewash

Delicate with prewash

Cotton

A CB

Care

Labels

Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Type of wash / Notes

A. Programme Selection Knob B. Temperature Selection Knob C. Spin Speed Selection Knob D. “On/Off” Button

Max. Load

5,0 Yes 1)Yes

2,0 Yes 1)Yes

1,5 Yes 1)Yes

5,0 – Yes

Detergents and Additives

Pre-

Main

wash

Softener Bleach Eco Intensive

wash

i i i i i

“Cold“

i : option / Yes: dosing required

Do not use liquid detergents.

For improved garment care, spin speed is restricted

to 700 rpm in this programme.

For improved garment care, spin speed is null

in this programme.

Special Options

Rinse

–

i i i

– – –

Rinse

Hold

Tempera-

ture

Speed

°C

Max. 95 800

Max. 60 700

Max. 40 700

Max. 95 800

Max. Spin

rpm

Coloured

Mixed Cotton/Synthet.

Synthetics

Delicate

Wool

Silk

Rinse + Gentle

Spin

Rinse + Spin –

Spin –

Gentle Spin –

Drain –

Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Normally soiled overalls ans sportswear made of cotton, polyester, polyamide and blends with cotton.

Curtains and delicate clothing, dresses, skirts, shirts and blouses.

Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.

If you select “Rinse Hold” do not leave items to soak for too long.

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

If you select “Rinse Hold” do not leave items to soak for too long. No spinning.

Programme for treating delicate laundry with starch or softener.

–

Programme for treating cotton or linen laundry with starch or softener.

Programme to spin cotton or linen laundry intensively with maximum spin speed.

Programme to spin delicate laundry gently with a restricted spin speed.

Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.

N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.

3,0 – Yes

2,0 – Yes

1,5 – Yes

1,0 – Yes

2,0 – –

5,0 – –

–

i i i

–

i i i

–

i i i

– – –

– –

i i

Max. 60 800

Max. 60 700

Max. 40 700

Max. 30 –

– 700

– 800

5,0 – – – – – – – – 800

2,0 – – – – – – – – 700

– – – – – – – – – –

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 10369

CONSUMPTION DATA

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes) Cotton 95 5,0 63* 1,80 2:05 Cotton 60 5,0 55 0,95 2:05 Cotton 40 5,0 55 0,55 2:05

Mixed Cotton/Synthetic 60 2,0 56 0,80 1:30

Synthetic 40 2,0 56 0,40 1:30

Delicate 40 1,5 60 0,55 0:45

Wool 40 1,0 60 0,50 0:40

Silk 30 1,0 60 0,30 0:50

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to the programme “Cotton 60°C”.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION

1. Load the machine, close the drum doors and check that they are properly locked.

2. Add detergents and additives into the dispenser to no more then the “MAX” level

mark, as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the programme selector knob to the desired programme.

4. Turn the temperature selector knob to the

Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.

“Eco” button

• The duration of the wash is extended and the

max. temperature reduced to save up to 40% of energy compared to a normal wash but maintaining good washing results.

“Intensive Rinse” button

• The amount of water is increased to ensure a

more intensive rinse.

• This option is particulary suitable for areas with very soft water, washing baby linen and people with detergent allergies.

desired temperature.

5. Turn the spin speed selector knob to the desired temperature. If the spin speed “ “ is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle.

“Rinse Hold” button

• The laundry remains in the last rinse water

without progressing to the final spin cycle to avoid creasing and prevent colours from fading.

• This option is particularly recommended for the “Synthetic” and “Delicate” programmes.

• This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.

Note: The programme selector knob stops on . Appliance in “Rinse Hold”:

• Press the “Rinse Hold” button again: the

programme will terminate automatically with the selected spin cycle.

• If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again.

PROGRAMME START

Turn on the tap and press the “On/Off” button . The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.

END OF WASH CYCLE

• The programme selector knob is in the Stop

position.

1. Press the “On/Off” button to switch off the machine.

2. Cancel the option.

3. Turn the tap off.

4. Wait for the lid to unlock (about 1 minute).

5. Open the lid and the drum doors and unload the machine.

CHANGE THE PROGRAMME DURING THE WASH CYCLE

1. Switch off machine by pressing the “On/Off” button .

2. Select the new programme.

3. Start programme by pressing the “On/Off” button again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the programme for a certain time and continue it later:

1. Press the “On/Off” button .

2. After the desired pause, press again the “ON/Off” button .

CANCEL PROGRAMME

1. Switch off the machine by pressing the “On/Off” button .

2. Set the programme selector to “Drain”.

3. Press the “On/Off” button again to start the “Drain” programme .

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 10369