Whirlpool AWO/D 8700 INSTRUCTION FOR USE
30106068GB.fm Page 1 Wednesday, June 27, 2007 5:27 PM
GB PROGRAMME CHART
A. “On/Off” button
B. Programme selection buttons
C. Option buttons
D. “Favourite” button
E. “Temperature” button
F. “Start delay” button
G. “Variable spin” button
H. “Start/Pause” button
I. “Drain/Reset (3sec)” button
J. Display
Programme
Cotton
Cotton
Tempe-
rature
70 - 95 °C
20 - 60 °C
Care
Labels
D E F G
Max
Load
- For temperature selection, respect the manufacturer’s recommendations on the
care label
kg
Normally to heavily soiled bed linen, table linen and underwear , towels, shirts etc.
8.0
made of cotton and linen.
At a temperature of 80°C or more, this programme eliminates bacteria, ensuring
sanitization of your laundry. The bacteria removal efficiency has been tested
8.0
following a similar methodology to the NF EN 13697 standard of Nov. 2001.
Type of wash/Notes
H
A
B
I
K. Programme sequence indication
J
}
C
KL N
}
L. “Door open” indication
M. “Buttons locked” indication
O
Your washing machine is equipped with
P
automatic safety functions which detect
and diagnose faults at an early stage
and react appropriately, e.g.:
M
N. “Water tap closed” indication
O. “Clean pump” indication
P. “Service” indication
Detergents and additives Special options Start
Pre-
Main
wash
❉
Softener Eco Easy
wash
3)
Yes
❉❉❉❉ ❉ ❉❉ ❉
ironing
Pre-
wash
Intensive
rinse
Rinse
hold
delay
2)
Variable
spin
Spin
Max
Spin
Speed
rpm
max.
Synthetics
Daily load
(60 min)
Quick wash
(30 min)
Delicates
Wool
Handwash
(Lingerie)
Spin
Rinse & Spin
Drain
❉
: optional / Yes : dosing required
1)
For improved garment care, spin speed is restricted in these programmes.
2)
Do not use liquid detergent when activating the “Start Delay”.
3)
Do not use liquid detergent for the main wash when activating the “Prewash” option.
20 - 60 °C
20 - 60 °C
20 - 30 °C
20 - 40 °C
20 - 40 °C
20 - 40 °C
20 - 60 °C
——
——
———
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
3.5
polyamide (Perlon, Nylon) or blends with cotton.
Slightly to normally soiled textiles made of cotton and/or synthetics.
6.0
Shortly worn outer clothing made of cotton, polyester , polyamide and blends with
6.0
cotton.
Curtains and delicate clothing, dresses skirts, shirts and blouses.
2.5
Only woollens, labelled with the Woolmark and identified as machine washable.
This programme (40°C) is tested and approved by The Woolmark Company for
2.0
machine washable wool.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
Up to a temperature of 30°C, this cycle is particularly suitable to treat delicate
lingerie (use of a laundry net strongly recommended).
2.0
This programme (40°C) is tested and approved by The Woolmark Company for
handwashable wool.
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc.
made of cotton and linen.
Offers highest economy in energy consumption by prolonged washing duration. Ideal to
8.0
be run overnight to additionally profit from the more favourable energy rates. To avoid
noise of spinning at night, set spin speed to “0” and start spin programme in the
morning, or define programme start with “Start Delay” accordingly.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton”
8.0
programme.
Same as the last rinse and the final spin in the “Cotton” programme.
8.0
Drain only - no spinning. Alternative method of terminating programme after “Rinse
Hold”. Press “Drain/Reset (3sec)” and then “Start/Pause” to start the “Drain”
programme.
3)
—
—
—
—
—
Yes
Yes
Yes
3)
Yes
Yes
Yes
Yes
❉
❉
❉❉❉❉ ❉ ❉❉ ❉
—
❉
——— —
❉
——
❉
——— —
❉
——— —
❉
———
❉
—
❉
❉
—————— — —
——
———
❉
—————— — ——— —
The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company
for the washing of Woolmark garme nts labelled as “machine wash” or “hand wash” pr ovided that the garments
are washed according to the instructions on the garment label and those issued in this programme chart.
M0620
1000
❉❉❉❉
❉❉❉
—
❉❉❉
❉❉❉
❉❉❉
1000
1000
400
❉❉❉❉
❉❉
❉❉❉❉
Whirlpool is a registered trademark of Whirlpool USA
5019 301 06068
1)
max.
max.
1)
1)
1)
max.
max.
max.
Black process 45.0° 100.0 LPI
30106068GB.fm Page 2 Wednesday, June 27, 2007 5:27 PM
CONSUMPTION DATA
Programme
Cotton
Cotton 60 8.0 77 1.52 2:10
Cotton with “Eco”
Cotton 40 8.0 77 0.85 2:05
Synthetics 60 3.5 48
Synthetics 40 3.5 44 0.55 1:20
Daily load (60 min) 40 6.0 79 0.70 1:00
Quick wash (30 min) 30 6.0 72 0.35 0:30
Delicates 30 2.5 60 0.45 0:50
Wool 40 2.0 60 0.65 0:45
Handwash 40 2.0 45 0.65 0:40
Handwash (Lingerie) 30 2.0 45 0.35 0:36
Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home
may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The time indicated on the display can deviate from the values in the table, because it takes into account the household
*
conditions applicable at that time.
To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
**
Reference Programme for Energy Label.
***
***
Tem p e rat u re
(°C)
95 8.0 82
60 8.0 69 1.36 2:20
60 8.0 75 0.95 4:00
ADD DETERGENTS, CLOSE THE DOOR
AND SELECT THE PROGRAMME
Add detergent as indicated on the front page and as
described in the chapter “Detergent and Additives” in
your Instructions for Use.
1. Push the
2. Select the
3. The
“On/Off”
signals that the washer is switched on.
corresponding programme button; it is marked by a
blue light.
temperature
display can be altered by pressing the “Temperature”
button or the “Variable spin” button.
button . The blue light circle
desired programme
and
spin speed
by pushing the
indicated on the
SELECT ANY DESIRED OPTION
When the combination of programme and additional
option(s) is not possible, the indication lights switch off
automatically. Unsuitable combinations of options are
deselected automatically.
“Eco” button
• With a modified temperature profile and a slightly
prolonged washing duration, the optimum
combination of excellent washing result and even
lower energy consumption is achieved.
“Easy ironing” button
• Can be used together with “Cotton”, “Synthetics” and
“Daily load” programmes to make ironing easier.
• Increases the water quantity and the clothes are spun
very gently.
“Prewash” button
• Only for heavily soiled loads (for example sand,
granular dirt) sensible. Increases the cycle time by
approximately 15 min.
• Do not use liquid detergent for the main wash when
activating the Prewash option.
Load
(kg)
Water
“Intensive rinse” button
• More water is added and rinse cycle is prolonged.
• This option is particularly suitable for areas with very
“Rinse hold” button
• The laundry remains in the last rinse water without
• This option is particularly recommended for the programmes
• It is particularly useful if you want to postpone spinning
• If you select “Rinse hold”, do not leave the laundry to
Terminate the “Rinse hold” option:
• P ress the
• If you do not wish to spin the clothes, push the
“Variable spin” button
• Every programme has a predefined spin speed.
• Press the button to set another spin speed.
• If spin speed “0” is selected, the final spinning is
Energy
(l)
(kWh)
2.40 2:10
**
0.95 1:35
**
soft water or for washing baby linen, and helps people
with allergies.
progressing to the final spin cycle to avoid creasing and
prevent colours from changing.
“Synthetics”, “Daily load (60 min)” and “Delicates”.
to a later time, or if you want to drain only.
soak for too long.
The programme stops to “Rinse hold” at the time
Note:
the “Rinse hold” symbol on the display lights up. The blue
light under the
will terminate automatically with the final spin cycle for
the present wash programme.
“Drain/Reset (3sec)”
Pause”
cancelled but intermediate spin peaks remain during
rinse. The water is drained out only.
“Start/Pause”
button to start the Drain programme.
Approx. Programme Duration
(hours : minutes)
“Start/Pause”
button flashes.
button ; the programme
button and then the
*
“Start/
SAVE YOUR FAV O URITE PROGRAMMES
If there is a programme setting which you use frequently,
the appliance offers the possibility to save one setting for
each programme so that it can be used again by just
pushing one button.
• Select the desired programme, temperature, spin
speed and option(s), push and hold the
button for at least 3 seconds. The lamp next to
“Favourites”
programme setting is saved.
Next time you want to use your individual programme
setting, select the programme, push the
button and start by pushing
If you want to replace the saved programme setting
by another one:
• Push the programme button, select temperature, spin
speed and options as desired and then press and hold
the
“Favourites”
previously saved programme setting will be replaced
by the new one.
shortly flashes and then lights up - the
“Start/Pause”
button for at least 3 seconds. The
“Favourites”
“Favourites”
.
START DELAY
The “Start Delay” allows to run the machine at the
consumer’s convenience, for example at night when
electricity is cheaper.
• Select programme, temperature, spin speed and options.
• Press the “Start Delay” button to select the delay time
up to 23 hours.
• Press the
The countdown of the delay time begins; the clock
symbol next to the delay time and the dot between
hours and minutes flash.
• The time delay indication disappears when the
programme starts and it is replaced by the remaining
programme time.
• Once having pressed the
the number of hours preselected can be reduced by
pressing and holding the “Start Delay” button. From 1
hour on, the delay time can also be reduced by minutes.
To cancel the “Start Delay”
..before you press the “Start/Pause” button:
• Select another programme or pre ss the
(3sec)”
..after having pressed the “Start/Pause” button:
• Press the
seconds - the start delay time disappears from the display .
“Start/Pause”
button.
“Drain/Reset (3sec)”
button .
“Start/Pause”
button for at least 3
button ,
“Drain/Reset
PROGR AMME START
Open the tap and press the
The blue light under the
The programme sequence indicator shows the current
programme phase, running from left to right through
Wash, Rinse, Spin/Drain.
“Start/Pause”
“Start/Pause”
button .
button is on.
“DOOR OPEN” INDICATION
Before starting and after end of a programme, the symbol
lights to show that the door can be opened. As long as a
wash programme is running, the door remains locked and
must on no account be forced open. In case you have an
urgent need to open it during a running programme, refer
to “Cancel (Reset) a running programme before the end”.
LOCK BUTTONS
You can lock the buttons of the control panel against
improper use (e.g. by children).
• P ress the temperature and the spin speed button
simultaneously and hold them for at least 3 seconds.
The key symbol on the display lights up.
• To unlock the buttons again: proceed in the same way.
RED INDICATIONS ON THE DISPLAY
“Water tap closed”
The appliance has no or insufficient water supply. Open
the water tap; if the indication still lights up, refer to the
“Troubleshooting Guide” in the Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether the drain
hose is kinked or the filter must be cleaned; in the latter case
refer to the Instructions for Use (“Removing the Filter”).
“Service”
Lighting up of the “Service” indication can be caused by a
fault in an electrical component. Refer to the
“Troubleshooting Guide” in your Instructions for Use; if
the fault persists, contact our After Sales Service.
PROGRAMME END
• The symbols of the programme sequence indicator
are dark, and the “Door open” symbol lights up.
1. Switch the machine off by pushing
2. Close the water tap.
3. Open the door and unload the machine.
4. Leave the door ajar to allow the drum to dry.
“On/Off”
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
1. Press the
programme. The light flashes.
2. Select the new programme, temperature, any options
and another spin speed if you want.
3. Press the
programme continues at the same position where the
previous programme was interrupted. Do not add
detergent for this programme.
“Start/Pause”
“Start/Pause”
button to pause the
button again. The new
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
The
“Drain/Reset (3sec)”
before the end.
• Press the
seconds. Any existing water is drained out before the
door can be opened.
“Drain/Reset (3sec)”
Whirlpool is a registered trademark of Whirlpool USA
button cancels a programme
button for at least 3
5019 301 06068
.
Black process 45.0° 100.0 LPI
Loading...