Whirlpool AWO/D 7110 INSTRUCTION FOR USE

30106212aGB.fm Page 1 Tuesday, September 30, 2008 10:41 AM

A. “Door open” indication

This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately, e.g.:

B.“Service” indication

C.“Water tap closed” indication

D.“Clean pump” indication

				Max
		Tempe-	Care	Load
	Programme	Tempe-	Care
	Programme	rature	Labels
		rature	Labels
				kg
	White Cotton /	70 - 95 °C		7.0
	Antibacterial	70 - 95 °C		7.0
	Antibacterial
	Cotton	20 - 60 °C		7.0
	Synthetics	20 - 60 °C		3.0
	Daily load	20 - 60 °C		4.0
	Quick wash	20 - 30 °C		4.0
	Delicates	20 - 40 °C		1.5
	SuperEco	20 - 60 °C		7.0
	Lingerie	20 - 30 °C		1.0
	Wool	20 - 40 °C		1.0
	Handwash	20 - 40 °C		1.0
	Rinse & Spin	—	—	7.0
	Spin	—	—	7.0
	Gentle Spin	—	—	1.0
	Drain	—	—	—
: optional / Yes : dosing required
1)	For improved garment care, spin speed is restricted in these programmes.

PROGRAMME CHART

H							E. Programme selector
H							F. “Start/Pause” button
}							F. “Start/Pause” button
}		A
C		A					G. “Spin” button
D		B					H. Programme sequence indicator
D		B
							I.	“Reset” button
		I					J.	“Start delay” button
E	F	J	K L		G		K. “Temperature” button
E	F	J	K L		G		L. Display
							L. Display
Type of wash/Notes		Detergents and additives							Special options				Max
		Pre-	Main	Softener Clean+		Pre-	Start		Easy	Intensive	Rinse	Spin	Spin
		wash	wash			wash	delay		ironing	rinse	hold		Speed
- Respect the manufacturer’s recommendations on the care label													rpm
Normally to heavily soiled bed linen, table linen and underwear, towels,
shirts etc. made of cotton and linen.
At a temperature of 80°C or more, this programme eliminates			Yes										max.
bacteria, ensuring sanitization of your laundry. The bacteria removal			Yes										max.

efficiency has been tested following a similar methodology to the NF
EN 13697 standard of Nov. 2001.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen,			Yes										max.
Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Slightly to normally soiled textiles made of cotton and/or synthetics.		—	Yes		—	—							max.
Shortly worn outer clothing made of cotton, polyester, polyamide and		—	Yes		—	—			—	—			max.
blends with cotton.		—	Yes		—	—			—	—			max.
blends with cotton.
Curtains and delicate clothing, dresses skirts, shirts and blouses.			Yes		—				—	—			1000 1)
Slightly to normally soiled bed linen, table linen and underwear, towels,
shirts etc. made of cotton and/or linen.
Offers highest economy in energy consumption by prolonged wash duration.		—	Yes		—	—			—				max.
Ideal to be run overnight to additionally profit from the more favourable		—	Yes		—	—			—				max.
energy rates. To avoid noise of spinning at night, set spin speed to “0” and
start spin programme in the morning, or define programme start with
“Start Delay” accordingly.
This programme is particularly suitable to treat delicate lingerie (use of		—	Yes		—	—			—	—			400 1)
a laundry net strongly recommended).		—	Yes		—	—			—	—			400 1)
a laundry net strongly recommended).
Only woollens, labelled with the Woolmark and identified as machine		—	Yes		—	—			—	—			1000 1)
washable.		—	Yes		—	—			—	—			1000 1)
washable.
Textiles made of linen, silk, wool and viscose marked as		—	Yes		—	—			—	—			400 1)
“handwashable”.		—	Yes		—	—			—	—			400 1)
“handwashable”.
Same as the last rinse and the final spin in the “Cotton” programme.		—	—		—	—			—				max.
In this programme spinning is intensive. Same as the spin cycle in the		—	—	—	—	—			—	—	—		max.
“Cotton” programme.		—	—	—	—	—			—	—	—		max.
“Cotton” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool”		—	—	—	—	—			—	—	—		1000 1)
programme.		—	—	—	—	—			—	—	—		1000 1)
programme.
Drain only - no spinning. Alternative method of terminating programme		— — — — —							— — — — —
after “Rinse Hold”.		— — — — —							— — — — —
after “Rinse Hold”.
									Whirlpool is a registered trademark of Whirlpool USA

5019 301 06212/A

Black process 45.0° 150.0 LPI

30106212aGB.fm Page 2 Tuesday, September 30, 2008 10:41 AM

CONSUMPTION DATA

Programme	Temperature	Load	Water	Energy	Approx. Programme Duration
Programme	(°C)	(kg)	(l)	(kWh)	(hours : minutes)*
	(°C)	(kg)	(l)	(kWh)	(hours : minutes)*
White Cotton / Antibacterial	95	7.0	74**	2.10	2:10
Cotton ***	60	7.0	54	1.19	2:20
Cotton	40	7.0	69	0.75	2:05
Synthetics	60	3.0	46**	0.80	1:35
Synthetics	40	3.0	42	0.40	1:20
Daily load	40	4.0	48	0.50	1:00
Quick wash	30	4.0	48	0.25	0:30
Delicates	30	1.5	60	0.50	0:45
SuperEco	60	7.0	69	0.84	4:00
Lingerie	30	1.0	45	0.45	0:40
Wool	40	1.0	60	0.55	0:45
Handwash	40	1.0	45	0.55	0:40

Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

*The time indicated on the display can deviate from the values in the table, because it takes into account the household conditions applicable at that time.

**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

***Reference Programme for Energy Label.

ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME

Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use.

1.Turn the programme selector to the desired programme. The display shows the programme duration

in hours and minutes as well as the predefined temperature. The “Start/Pause” button blinks.

2.The temperature can be altered by pressing the “Temperature” button.

3.The indication lamp of the predefined spin speed

lights up; in case you want to set another spin speed, press the “Spin” button .

SELECT ANY DESIRED OPTION

Push the button of any option desired - the respective indication lights up.

When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically.

“Clean+” button

•Choose this option if you use an in-wash additive for stain removal (powder, for example “Vanish”) - it will optimize the additive’s efficiency to get better wash performance and stain removal.

•Selectable for programmes “Cotton” and “Synthetics”; choose temperature of 30 or 40°C and use with maximum load.

•Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). Respect the manufacturer’s dosing instructions.

•Prolongs the programme by approx. 10 to 15 minutes.

•Appropriate for use of stain removers and bleaches on oxygen basis. Chlorine or perborate bleaches must

not be used! “Prewash” button

•Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 15 min.

•Do not use liquid detergent for the main wash when activating the Prewash option.

“Easy ironing” button

•Can be used together with “Cotton”, “Synthetics” and “Daily load” programmes to make ironing easier.

•Increases the water quantity and the clothes are spun

very gently.

“Intensive rinse” button

•More water is added and rinse cycle is prolonged.

•This option is particularly suitable for areas with very soft water, washing baby linen and helps people with

allergies.

“Rinse hold” button

•The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing.

•This option is particularly recommended for the programmes “Synthetics”, “Daily load” and “Delicates”.

•It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.

•If you select “Rinse hold”, do not leave the laundry to soak for too long.

Note: The programme stops to “Rinse hold” at the time the “Rinse hold” light in the programme sequence

indicator is on. The indication lamp next to the “Start/ Pause” button blinks.

Terminate the “Rinse hold” option

•Press the “Start/Pause” button ; the programme will terminate automatically with the final spin cycle for the present wash programme.

•If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme

and press the “Start/Pause” button .

“Spin” button

•Every programme has a predefined spin speed.

•Press the button to set another spin speed.

•If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. The water is drained out only.

START DELAY

The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating the “Start Delay”.

•Select programme, temperature and options.

•Press the “Start Delay” button to select the delay time by 1 to 23 hours;

•Press the “Start/Pause” button .

The indication light next to the “Start Delay” button lights up and the countdown of the delay time begins. The dot between hours and minutes of the indicated delay time as well as the light of the start delay button will keep blinking until the programme starts.

•The time delay indication disappears when the programme starts and it is replaced by the remaining programme time.

•Once having pressed the “Start/Pause” button , the number of hours preselected can be reduced by pressing and holding the “Start Delay” button. From 1 hour on, the delay time can also be reduced by minutes.

To cancel the “Start Delay”

..before you press the “Start/Pause” button :

•Turn the programme selector to another position or press the “Reset” button .

..after having pressed the “Start/Pause” button

•Press the “Reset” button for at least 3 seconds - the start delay time disappears from the display.

PROGRAMME START

Open the tap and press the “Start/Pause” button . The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain.

The display shows the remaining programme time. Due to variations in load and temperature of inlet water, the remaining time is newly calculated in certain programme phases. If this is the case, an animation appears on the display.

“DOOR OPEN” INDICATION

Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”.

RED INDICATIONS

“Service”

Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service.

“Water tap closed”

The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use.

“Clean pump”

Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”).

PROGRAMME END

•All the lights of the programme sequence indicator

are off, and the “Door open” indication lights up.