Whirlpool AWO/D 6080 PROGRAM CHART

30106157GB.fm Page 1 Thursday, March 20, 2008 6:30 PM

GB PROGRAMME CHART

	A. “Door open” indication			G			E. Programme selector
	This washing machine is equipped with						F. “Start/Pause” button
			C	}	A
	automatic safety functions which
	detect and diagnose faults at an early		D		B		G. Programme sequence indicator
	stage and react appropriately, e.g.:
	B. “Service” indication				H
	C. “Water tap closed” indication			E			H. “Reset” button
	D. “Clean pump” indication				F
		Max		Type of wash/Notes		Detergents and additives			Special options		Spin
		Load				Pre-	Main	Softener	Half	No	Speed
	Programme	Care				wash	wash		load	spin
		Labels
		kg	- Respect the manufacturer’s recommendations on the care label.								rpm
	Cotton	6.0	Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen,			Yes	Yes				max.
	with prewash
			table linen, underwear, shirts etc.).
	95 °C	95 °C
	Cotton	6.0
	60 - 95 °C
		60 - 95 °C	Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of			—	Yes				max.
	Cotton		cotton and linen.
		5.0
	40 °C
		40 °C

Synthetics						2.5	Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide	Yes	Yes				max.
with prewash
							(Perlon, Nylon) or blends with cotton.
60 °C	60 °C
Synthetics						2.5	Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide	—	Yes				max.
30 - 40 - 60 °C	30 - 40 - 60 °C						(Perlon, Nylon) or blends with cotton.
Delicates						1.5	Curtains and delicate clothing, dresses skirts, shirts and blouses.	—	Yes				max.
30 °C
	30 °C
Quick wash						3.0	Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton.	—	Yes				max.
30 °C
	30 °C
Wool							Only woollens, labelled with the Woolmark and identified as machine washable.	—
						1.0	This programme (40°C) is tested and approved by The Woolmark Company for machine		Yes				max.
Cold - 40 °C
	- 40 °C						washable wool.
Handwash							Textiles made of linen, silk, wool and viscose marked as “handwashable”.	—					400 1)
						1.0	This programme (40°C) is tested and approved by The Woolmark Company for handwashable		Yes
30 - 40 °C
	30 - 40 °C						wool.
Rinse & Spin			—			5.0	Same as the last rinse and the final spin in the “Cotton” programme.	—	—		—		max.
Spin			—			5.0	In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.	—	—	—	—		max.
Gentle Spin			—			1.0	In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.	—	—	—	—		max.
Drain			—			—	Water is drained only without any spinning.	—	—	—	—	—	—

: optional / Yes : dosing required		The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company for the washing of	Whirlpool is a registered trademark of Whirlpool USA
1)	For improved garment care, spin speed is restricted to 400 rpm in this programme.	Woolmark garments labelled as “machine wash” or “handwash” provided that the garments are washed according to the

instructions on the garment label and those issued in this programme chart. M0512	5019 301 06157

Black process 45.0° 100.0 LPI

30106157GB.fm Page 2 Thursday, March 20, 2008 6:30 PM

CONSUMPTION DATA

	Programme	Temperature	Load	Water	Energy	Approx. Programme Duration
		(°C)	(kg)	(l)	(kWh)	(hours : minutes)
	Cotton	95	6.0	59*	1.90	2:00
	Cotton with “Eco”**	60	6.0	49	1.02	2:20
	Cotton	60	6.0	49	1.14	2:10
	Cotton	40	5.0	56	0.70	2:00
	Synthetics	60	2.5	50*	0.80	1:35
	Synthetics	40	2.5	46	0.50	1:20
	Delicates	30	1.5	60	0.50	0:45
	Quick wash	30	3.0	41	0.40	0:30
	Wool	40	1.0	60	0.50	0:45
	Handwash	40	1.0	45	0.50	0:40

Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

*To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

**Reference Programme for Energy Label.

ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME

Add detergent as indicated on the front page and as described in your Instructions for Use. Close the door and turn the programme selector to the desired programme and temperature. The indication lamp next to the “Start /Pause” button blinks.

SELECT ANY DESIRED OPTION

Push the button(s) of any option(s) desired - the respective indication lamp lights up.

When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically.

“Half load” button

•Reduces water consumption, above all during rinsing.

•Suitable for lightly soiled laundry and small loads (max. 3 kg).

“No spin” button

•Especially for delicate garments to avoid wear and tear caused by the spin.

Note: with the “Cotton” and “Synthetics” programmes, a short spin cycle is provided in any case, even if the “No spin” option has been selected, in order to optimize rinsing results.

PROGRAMME START

Open the tap and press the “Start/Pause” button . The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain.

When the programme phase is finished, the corresponding indication goes off.

“DOOR OPEN” INDICATION

Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”.

RED INDICATIONS

“Service”

Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your “Instructions for Use”; if the fault persists, contact our After Sales Service.

“Water tap closed”

The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use.

“Clean pump”

Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”).

PROGRAMME END

•All the lights of the programme sequence indicator are off, and the “Door open” indication lights up.

1.Turn the programme selector to the “Off/O” position.

2.Close the water tap.

3.Open the door and unload the machine.

4.Leave the door ajar to allow the drum to dry.

CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START

1.Press the “Start/Pause” button to pause the programme. The light blinks.

2.Select the new programme (with temperature), any options and another spin speed if you want.

3.Press the “Start/Pause” button again. The new programme continues at the same position

where the previous programme was interrupted. Do not add detergent for this programme.

CANCEL (RESET) A RUNNING

PROGRAMME BEFORE THE END

The “Reset” button cancels a programme before the end.

•Press the “Reset” button for at least 3 seconds. Any existing water is drained out

before the door can be opened.

Whirlpool is a registered trademark of Whirlpool USA

5019 301 06157

Black process 45.0° 100.0 LPI