Whirlpool AUSTRIA 1400 INSTALLATION

GB AUSTRIA 1400 PROGRAMME CHART

Whirlpool is a registered trademark of Whirlpool USA

;

A. Programme Sequence Indication B. “Start/Pause” Button

C. “Door Open” Indication D. “Spin Speed Reduction” Button

Selecting any option the indication lights up. When the combination of programme, additional options and temperature is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically.

❉

: optional / Yes : dosing required

For improved garment care spin speed is restricted to 1000 rpm in this programme.

For improved garment care spin speed is null in this

programme.

Programme

Cotton

Synthetics

Daily

Short

Delicates

Wool

Silk

Rinse & Spin

Spin

Gentle Spin

Drain

Care

Labels

— —

—

Type of wash/Notes

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

With heavily soiled laundry the additional “Prewash” option can be selected as well.

Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Slightly to normally soiled textiles made of cotton and/or synthetics.

Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton.

Curtains and delicate clothing, dresses skirts, shirts and blouses.

Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.

If you select “Rinse Hold” do not leave items to soak for too long.

Textiles made of linen, silk, wool and viscose marked as “handwashable”.

If you select “Rinse Hold” do not leave items to soak for too long. No spinning. Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive. Same as the spin cycle in the “Cotton”

programme. In this programme spinning is gentle. Same as the spin cycle in the “Wool”

programme. Drain only - no spinning. Alternative method of terminating programme after

“Rinse Hold”.

Max

Load

5.0

2.5

3.0

1.5

1.0

5.0

1.5

Detergents and additives Special options Max

Softener Main

❉

❉ ❉

Wash

Yes

———

——————

Pre-

wash

Pre-

wash

Vor-

wäsche

Intensive

Rinse

Intensiv

spülen

Rinse Hold

Spül-

stopp

Spin Speed

Reduction

Schleudern

❉❉ ❉ ❉ ❉

——

❉❉

—— —

❉❉ ❉

—

❉❉

❉

—

❉❉ ❉

❉

Spin

Speed

rpm

1400

1000

1400

1000

0 1400 Spülen & Schleudern 1400 Schleudern

1000

———————— —

Programme

Selector

Koch- Buntwäsche

95°, 60°, 40°

Pflegeleicht

60°, 40°

Tageswäsche

40°

Rapid

30°

Feinwäsche

40°, 30°

Wolle

30°, cold

Seide

30°

Schon Schleudern

Abpumpen

5019 301 10230

Whirlpool is a registered trademark of Whirlpool USA

CONSUMPTION DATA

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx.

Programme

Duration

(hours : minutes)* Cotton 95 5.0 53** 1.90 2:00 Cotton 60 5.0 48 0.95 2:20 Cotton 40 4.5 48 0.60 2:05

Synthetics 60 2.5 55 0.80 1:30 Synthetics 40 2.5 55 0.60 1:20

Daily 40 3.0 45 0.50 1:00

Short 30 3.0 37 0.40 0:30

Delicates 40 1.5 60 0.60 0:45

Wool 30 1.0 60 0.30 0:40

Silk 30 1.0 45 0.30 0:40

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the

household conditions applicable at that time.

** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump

drains the water out.

ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME

Add the detergent as described in the programme table or in the chapter “Detergents and Additives” in the booklet.

1. Turn the

programme selector knob

to the

desired programme and temperature.

2. After taking some seconds for calculation, the pilot lamp of the

3. The

“Start/Pause”

programme sequence

predefined spin speed indication

button is flashing.

and the

corresponding to the selected programme lights up.

SELECT ANY DESIRED OPTION

Selecting any option the indication lights up. When the combination of programme,

additional options and temperature is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically.

“Prewash” button

• Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases approximately 15 min.

“Intensive Rinse” button

• More water and a longer time in rinse cycle is added.

• This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing.

• This option is particularly recommended for the programme “Synthetics”, “Daily” and “Delicates”.

• This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.

The programme stops to “Rinse Hold” at

Note:

the time the “Rinse Hold” light in the programme flow indication is on.

Terminate the “Rinse Hold” option:

• Press the “Rinse Hold” button again; the programme will terminate automatically with the final spin cycle for the present wash programme.

• If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the

“Start/Pause”

button again when flashing.

“Spin Speed Reduction” button

• Every programme has an automatic predefined maximum spin speed.

• Press the button to set another spin speed.

• If the spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. The water is drained out only.

PROGRAMME START

Open the tap and press the button. The pilot lamp of the

“Start/Pause”

button lights up. The indicator lamps show the sequence reached

in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin.

When the sequence of the programme is finished the corresponding lamp goes out.

DOOR LOCK

The door can be opened when the “Door Open” indication is on.

PROGRAMME END

• All the lights of the programme sequence indication are off.

1. Turn the programme selector to the “ ”

position.

2. Turn the water supply tap off.

3. Open the door and unload the machine.

4. Close the tap and leave the door ajar to allow

the drum to dry out.

CHANGE THE PROGRAMME, OPTIONS AFTER PROGRAMME START

1. Press the

“Start/Pause”

button to pause the

programme. The light flashes.

2. Select the new programme (with

temperature), any options and another spin speed if you want.

3. Press the

“Start/Pause”

button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme.

CANCEL A PROGRAMME BEFORE THE END

1. Press the

“Start/Pause”

button to pause the

programme. The light flashes.

2. Set the programme selector to “Drain”. The spin indicators show

3. Press the

“Start/Pause”

“0”

button to start the

drain programme.

5019 301 10230